AMERIGLO Optic Compatible Sight Set for Glock - XL Tall Green Tritium 3 dot Sight Set White Outlines .315" F .394" R

These look great on my airsoft setup. Install required a pusher tool (or a punch if you are a brute). Glows well and easy to pickup with the eyes.

Good quality sights. Worked great for a lower 1/3 co-witness with a Trijicon RMR.

Perfect fit and cowitness with OSITE SE enclosed red dot on my G17 gen 6. Highly recommended.

Put them on my 47. Front went on easy obviously. Rear sight was tight, EXTREMELY tight! They’re steel, which should be more durable than the plastic glock oem set. Much brighter than my 19x factory night sights and the truglo set on my 17mos. Didn’t have a sight pusher but DID have a bench vice so I decided to wing it. Pushed them in with the vice and a piece of key steel. Then had to tap them in place with a brass punch without having to sand the dovetail down. Took a bit to zero them properly. I figured they would be scratched up from the punch marks but they’re surprisingly tough because there were no marks that I could see. Should you try my method to save money? Absolutely NOT, just get the sight pusher!

good quality for the money, it took too long to arrive.

Great sights nice night vision

I got this set to replace an older (2013) set of ameriglo sights on a 2nd gen glock 19. I did a 2 day pistol course and apparently did not lock-tite the front sight well enough, as it came off at the beginning of the first day. I did notice it getting looser previously, but forgot about it before the class. I just used the front sight out of this new order. They have apparently changed the design, as the new front sight has a proportionately larger and bolder dot, making it easier to pick up quickly. These sights are easy to install (the front is a breeze but requires a front sight tool (NOT included) and PLENTY of lock-tite. The rear was fairly easy to do as far as dovetail sights go if memory serves; mark the center of the stock sights on the slide with a pencil, then use a brass punch and hammer to drive out the old and in the new, aligning with the mark you made on the slide) look and feel high-quality and are bright and bold. My ~4 year old sights are still going strong, and in fact the slightly brighter new front sight helps me pick it up more easily. Highly recommend these.

I installed this on my Glock 21 with a Holosun 507comp. The original Glock sights were low and I couldn't cowitness. These sights lined up perfectly. Be warned, you will need the sight removal tool to remove this sight. It was TIGHT, but I got it off neatly. And you will need the sight tool to complete the install. Maybe you could get away with other methods. But I'm a mechanic and I'm from the proper tool for the proper job school... My only complaint is that the sights arent as bright as I thought they should be for night sites.