SBR20-800mm Linear Rail Linear Rails and Bearings Kit 2Pcs SBR20 800mm Long Fully Supported Shaft Guide with 4Pcs SBR20UU Linear Bearing Slide Block Linear Guide for CNC Equipments

Slides very smooth and works perfectly.

Installed these rails on my concrete plasma machine and so far they work s long as you make sure that no debris get into the bearings.

Great rails but with just a little bit of flex. I used these for a router sled. There were two drawbacks. The first was hunting for the correct screw size of the holes on the mounting blocks. (Metric6 by the way) The second if a little bit of flex in the rails. For a full size router I may have to go back and add some steel underneath the rails so they don't sag.

Product was fine, but I am missing the end alignment dowels which wasn’t a big deal because I am not in a rush. Reached out to the manufacturer for resolution with no response. When you purchase anything a big part of quality is support. That’s why they received one star.

These worked great for my project!

Used to build goose house opener with 18" lift, holding the two sides of big sliding doors in place. Initially, I tried to buy 1 inch U channel, but those rails are cheaper, stronger, and smoother.

very hefty rails no bending under the weight of a plunge router and my weight reaching over the work piece. they a bit noisy and probably could use more grease but that would cause too much dust buildup. came with hardware screws and a stopper handle but still had to purchase more since they were to long for my application. as a side note i accidentally purchased the wrong size and were too short to complete the task but worked as advertised. very satisfied with this prodcut.

Works pretty good so far. Not too hard to align. Fairly smooth.