Finish Line Ceramic Grease

稠度、持ち共によし。いろいろグリスを使いましたがこれが一番です。ハブであろうが、BBであろうが使えます。大きいの買ったほうが結局得ですね。

Il prodotto oltre ad essere di ottima qualità, è utile e di valida alternativa per l'ingrassaggio di tutti quei meccanismi che sono a bassa numero di rotazione come per esempio serrande in casa, porte, meccanismi e leveraggi auto e anche cuscinettin sterzo di moto e scotter. Di fatto il prodotto non è molto duro ma attacca bene e grazie alla ceramica garantisce un'ottimo ingrassaggio di sfere e cuscinetti bici. Personalmente l'ho usato anche per lubrificare con successo cavi cambio e freni V-Brake della bici. Consigliato.

So, I spent some time reading about grease, far more than any normal person should, and learned a few things. For the most part, there are no better greases than Industrial and Automotive grease. They have been refined and improved for countless years and produce very good quality greases. There are a lot of specialty greases too, but are they any better? I have an old set of Shimano Deore hubs from my Kona Process that are noisy and have seen better days, so I decided to experiment using three greases that I have available. Phil Wood: I have used Phil’s exclusively for 25+ years on everything with very good results and no complaints . 76 Dynalife GC-LB #2 EP Lithium Complex: I use this on RC helicopters bearings as it holds up very well and stays inside the bearings with little to no fly-out under high RPMs. Finish Line Ceramic: Just purchased it. I tore down, cleaned and repacked the hubs with each grease, my results below. Your results may vary. Phil: Spins freely but still very noisy. I can hear and feel roughness in the bearings. 76 Dynalife: A little more resistance that the Phil grease and quite a bit smoother. Better that the Phil’s grease on worn bearings but still sounding noisy and rough. Finish Line Ceramic: More resistance that the other two greases but they run very quiet, almost like new. Put them under load and spun them for a while. A small amount seeped through the seals and they seemed to loosen up a bit. Still very quiet and smooth. My verdict: With new or unworn bearings, both the Phil and Dynalife would be a good option with the Dynalife being bit smoother. With new OR worn bearings, the Finish Line Ceramic is VERY good. You can’t go wrong with this grease, it does what they claim. I recently rebuilt the pedals on my Kona using Phil’s grease. I will rebuild the ones on my Specialized with Finish Line and see how they feel. They have many, many thousands of miles on them since the last rebuild.

good

Brilliant product.decided to by this over the small tubes as better value for money