License Plate Holder Fender Eliminator Rear Tail Tidy LED Brake Lights Turn Signal For Suzuki DRZ400 S/SM DR-Z (Clear)

Value for money and brightness are great at night! I like how the turn signal pulses outward. I think most negative reviews I'm seeing are due to install error but if you have a multimeter it makes it very clear how to install. I used a bunch of alligator clips to connect the wires to make sure the lights worked very quickly before installing. I did have to get some wire for the third wire as LEDs use three wires where stock uses two. The red wire is constant power. The green is intermittent so that will be the actual turn signal/brake signal. I spliced all green wires into the break constant power wire. Again all of this is easy if you have a multimeter, have a bit of extra wire, and a solder or alternative way of connecting wires. I'm shocked at the price so even though the lights look good I'm really curious how long they will last. Will update my review when the turn signals die.

Fits US license plates. Bright stop light. Minus one star because the turn signals do a mini flash before doing the sequential flash, even after changing the blink controller to digital and putting LED signals on the front too.

Cheaply made; broke after occasional riding over three months. The bracket was tight, not vibrating; the weld failed; the plate, brake light, plate frame, and wire fell off, hit my tire got shot up and hit me in the back while riding. Don’t buy this, could have blown up my tire and taken my life.

Used them for a mini bike and worked perfect. The only thing is the red cover for the light needs to be taken off and sealed properly with sealant

Overall, the look is good but the functionality not so much. The white led turn signals are ok, at night. The red tail light does not go bright when you apply the breaks. Instead, the white plate light comes on, and the signals go to orange tracing hazards when you apply break. Further, the housing at the bottom of the light has a gap such, water will easily get in. Also, the wire harness is half the length it needs to be.

These lights are cool and of average quality for the price - they don't even advertise that the blinkers do a cool directional animation. As others have mentioned there are no instructions but no one yet has provided the correct wiring which is below:Brake Light is straight forward:Yellow goes to White on DRZ - constant powerGreen goes to Grey on DRZ - BrakeBlack goes to Black/White on DRZ - GroundIndicators the color will vary on the DRZ side, however black/white is always ground, and whatever the other color is is indicator powerIndicator wiring:Black goes to groundGreen goes to the "other wire" from the indicator leadsRed gets tied into the brake wires (green -> grey). This will make the indicators light up bright white - i personally just did not connect the red from indicatorsDebugging - if you are getting just a small yellow flash, you need to buy a LED Flasher relay and replace that. Once this is done, you will see a nice smooth animation for the indicators.

Easy installation on 2022 Suzuki Dr 400s . Nice!!

Center brake/running light didn’t work out of the package - had to swap the one it came with to the factory light. Turn signals flicker and flash white. Need to purchase an additional flasher relay to get it working properly