🔌 Connect Your Ideas with Confidence!
The YUNGUI 5PCS Perf Board Stripboard is a high-quality, single-sided PCB board designed for DIY Arduino soldering and electronic experiments. Measuring 90x150mm, it features a durable FR4 glass fiber construction, 1mm hole diameter, and 1440 tie points for versatile circuit design. With labeled rows and columns for easy operation and a 12-month warranty, this product is perfect for both hobbyists and professionals looking to elevate their electronic projects.
| Manufacturer | YUNGUI |
| Part Number | HJF-023ZF |
| Item Weight | 5 ounces |
| Product Dimensions | 5.91 x 3.54 x 0.05 inches |
| Item model number | HJF-023ZF |
| Size | fiber glass stripboard |
| Material | epoxy |
| Batteries Included? | No |
| Batteries Required? | No |
B**E
Experimental circuit board
Nice boards, the holes line up well with DIP chips and other standard parts.I also like the mounting holes that are provided.
D**D
Good product
The perf holes are accurate, and it worked well.
B**I
I like em!
I like how these are patterned out like a breadboard! Great addition to my Electronics Laboratory Bench!
C**N
Great product for prototyping.
Easy to use. Great value. Stands up well to heat. Pads are well attached.
A**G
Works well
Works as expected
S**S
Nice quality prototyping board.
I like the quality and I like the design of these prototyping boards. Handy for a lot of electronics projects.
L**N
OK for small projects
The board is thin but sturdy, however the copper leads are very delicate. Too much heat and they burn right off. A small tug from a wire can easily peel them off. Also it's not easy to fill in the holes with solder. On the positive side, it's very easy to make an intentional break in the circuit by cutting or scraping a lead with a hobby knife, and it's very easy to use a Dremel to cut the board down to a smaller size.I don't think I'd buy them again, but they're fine for small projects and temporary mockups. Comes in a pack of 5, 15 x 9cm, 1.2mm thick, 48 columns by 30 rows. (I purchased these to build the 1980s Usborne Robot because the dimensions are similar to Veroboard and close enough to the book's schematic with slight alterations.)
B**N
Great prototyping boards
Would like to have boards available with power supply routing tracks already etched around the perimeter or half way around the perimeter of the board
Trustpilot
2 weeks ago
1 week ago
