VEVORAuto Body Stud Welder 800 VA Slide Hammer Dent Puller 1600A Panel Beaters Removal Repair 110V

Someone had backed into my front drivers side fender just beside the light. I could not find an old school dent puller like when I was in high school and I searched all over. I had read some reviews on the product and figured I would give it a shot. Man what a great product I wish they had known about something like this when I was in school I would have definitely bought one way back then because this thing works great. 110 power source easy to put pins in connect to metal, hold trigger and it welds the pin right to the metal then you take a wrench and undo the pin for the unit and attach the slide hammer to it and give it a couple yanks and out comes the dent. Works as it advertised and very well I might add.

Works perfect on aluminum panels and casting. Cut my repair time down to half the time. Tools are good and overall quality is great.

Power switch would light up but front panel display did not. Using vevor product support, phone number on amazon is disconnected. Went to vevor website and opened support ticket. They asked for video and i uploaded one, vevor system not easy to upload. I get a responce two days later from vevor that they assume issue resolved. So i reply and uploas video again using the we service and they get the video, wait another day, responce they want me to take init part and look for a wire that might not be connected and or control board is bad. I take cover off, inspect and could not find anything obvious that would cause unit not to work. I decided to return for refund. Which amazon says could take up to 30 days.

This unit is heavy as expected. Must make contact with bare metal. Timed weld is adjustable. Push unit against metal to activate, then pull trigger to weld. Rods hold to metal like a dream. Don’t wiggle rods to remove from vehicle as this will leave a hole. Just use a pair of diagonal cutters.

Well when I received it would not do anything and My old Snap-on had seen better days. I needed to finish up a couple appointments that had body work to be done. But had no working stud welder. I had to get them out. So I took the new one apart to see if I could find what might be wrong. Sure enough their was a problem. One of the wires going to the transistor was loose I solider the wire in place and it worked fine but I have never used the wiggle wires before one the washer attachments before and the pamphlet that come with it was useless no instructions at all.!!!!

The product works well. It must be pushed hard and turned to spot weld. Good product.

It works but doesn't like extensions cords and even then gives trouble but better than nothing

I've used this on multiple projects and it comes through every time.