RV Designer E401, Stick-On Level, 2 Per Pack, Exterior Hardware

I use these on my travel trailer to check that it is level, and they work very well. I have actually had these on two different trailers. I place one on the side and the other on the rear. They adhere very well and are actually difficult to remove. Understand that once you put them on to the trailer, it is going to take some effort to get them off. On my 1st trailer I installed these and they worked flawlessly for the years that I had it. On the new trailer, I installed them and very quickly one of the fluid filled tubes broke somehow. I suspect the temperatures outside had something to do with it. I contacted the company to inquire about a replacement tube. They said that the tubes are easily removed and they would send me a replacement. They actually sent me two new levelers when I only needed one. Great customer service :)

I installed Very easy to use One week later the one on side of trailer was busted and liquid had leaked out It might have been because this one was on west side in the sun I ordered another set Will see if lasts longer

These RV Designer E401 stick-on levels definitely make leveling my camper a lot easier. The installation was simple — I used a speed square to line them up straight on the frame. In my setup, you can actually watch the bubble move as the hitch jack is lowered, which is super handy. The printed degree markings do feel a little cheap and I could see them wearing off eventually, but for around $4 a pack, I really can’t complain. They do exactly what I need them to do and make leveling much quicker. Good value!

for my camper to level out...works great

The stick on level for the R V worked as advertised. Maybe I should qualify that statement. One of them did. The other did not have any liquid or a bubble and on further examination I found that the tube was broken on the end. Being the cobbler that I am, I took the tube out, filled it with antifreeze and left a small bubble of air in the end. I mixed up some epoxy and covered the end. It is not as it was from the factory but it serves the purpose.

I purchased a set last year and putting them using the 3M tape provided worked fine on my PopUp Camper. the flat top design allowed me to put it on where I knew it had to be straight & level. But when I went to use the supplied screws, that where I had problems. Once the levels were attached using the tape, I drilled some pilot holes but the screws were so cheep, one sheared right off while a second stripped its threads.

Works great!

Bought these. Stuck on well, once they get warm, about 80 plus degrees, or if in the sun, the bubble disappears. AFter about 90 degrees the fluid turns clear and then they are useless. Came out the other day, and they were on there maybe 5 days, the one in the sun literally exploded and is gone. These look the same as the name brand ones, which I've used the name brand ones for years and zero issues or anything like this. pass on these and just get the namebrand ones. Now I have to remove these and buy new ones.

Installer ceci dans mon VR et ceci facilite l’installation des bloc sous les roues quand je stationne le VR car le niveau vous l’indique ,

لم استخدمه بعد

Easy to install. Used the sticky and screws.

perfect

So far the sticky tape is working on it’s own. Makes them easy to install. They seem accurate.