Aokin 3D Printer Bed Springs, 8mm OD 20mm Length Compression Mould Die Springs Light Load for Creality Ender 3, Ender 3 Pro, Ender 3 V2, Ender 3S 3D Printer, 10 Pcs

The bed on my Elegoo was constantly having to be re-leveled. I replaced my original springs with these & I can say I’m leveling about 50% less now. For the low cost it’s hard to argue with the results!

These are much better at keeping the print bed level between prints than the stock springs. I can't recommend these enough.

They do the job! I used these for some projects that required these types of springs. I do need to replace my bed springs soon so I will be giving these a go

Heavy duty springs

I originally bought these for my Ender 3 and they are perfect on it. However I recently purchased a CR10 I had hope that I could use the extra springs on it and unfortunately the are way too short. I've printed spacers I found on thingiverse and hopefully they work. I gave them for starts because they work great on my ender three, but I can't give them five stars, as they are supposed to work on the CR10 as well.

Purchased these springs after picking up a 2nd hand Ender 3 V2. Seller said it had adhesion issues they could never get right, got the printer home and tried to level the bed and noticed a sloppy set of stock springs that had to go. Installed these and had no problems moving forward.

Does the job it’s intended for.

The springs that I originally used to level my 300x300mm build plate were just a little too small and it was difficult to get the bed perfectly level. These springs were just the ticket. I needed 8 of the 10. I consider these to be the perfect tension for leveling a heated bed. You do not want a loose spring or the bed will move slightly during printing, giving you uneven Z banding. These have just the right amount of stiffness.If you find this review to be of value to you, please click the "Helpful" button below