Bahco Ergo Pocket Scraper

I purchased this item to prep my exterior shingle for paint, but wound up testing it in a room I am remodeling.Although the packaging was a little shoddy, the extremely rigid handle would have endured any mis-treatment during shipment, as well as being dropped from 30' from a ladder. The grip is ergonomic, however may not be suited for heavy, large area scraping (try the other model w/ the knob). The carbide blade that came with the item is sharp, and its triangular shape allows you to either get deep into a cavity, or create a -V- for filling. The included case is also well constructed and receives the unit snugly and secures it well. The only draw-back is that the clip in which you attach the holder to your belt should, in my opinion, be a loop; I have actually pulled the scraper and holster both off my belt due to the snug fit.I initially used the scraper to prepare a drywall room for paint and trim, scraping paint globs, roller lines and misc. bumps from the wall. It worked like a razor would. Clean and precise, which amazed me. If the roller mark width was less than the blade width, it would remove only the raised paint, leaving the rest only scuffed. Using it for half hour justified the purchase price by saving me the cost of numerous DA sander discs that would have gummed up in no time.Finally, I tried it on the cedar shingles with multiple layers of bad paint. PERFECT. So sharp and stable, I didn't get the typical chatter you would expect form cheap blades. Now I have to get the larger one for broader area removal. I know I won't be disappointed!

The Bahco scraper is amazing. I have been using it to scrape polyurethane finish off of kitchen cabinets and it works great. The blade is super sharp and scrapes the wood to a smooth finish. For tight corners you can turn the blade so the point of the blade is out and this is helpful for getting the last little bit of finish off of the wood. I also purchased the teardrop blade and that has been invaluable for scraping some of the curved areas of the cabinet doors. Again the blade is super sharp and scrapes to a smooth finish. You do have to be careful with both blades to avoid catching them on an imperfection in the wood because this can throw the blade off line and cut into the wood. The scratches typically aren't that deep and can be sanded out easily. I have refinished an entire set of kitchen cabinets and the blade is still going strong. No sign of dulling. This is all I have used this tool for so far but I am impressed with the quality and usefulness for the amount spent. I highly recommend this product.

I bought this particular scraper for my restoration business because itsutility and a great value for the money, easy to use, versatile for small and intricate places. I also liked the balance and speed and is light weight.

This thing is small but mighty. I used to scrape historic windows for repainting and this thing was so effective because of applying similar pressure but with such a smaller footprint than wider scrapers.As long as you keep the blades sharp this thing is awesome.

I have some mixed experiences with this scraper.First off, the handle is excellent. It is large, but not too large, just big enough to have a good grip at funky angles.The issue I had was with the provided carbide cutter. The cutting surface is not flat, I have verified this on a leveling block. I am not sure if this is by design or not, but I had to spend a few minutes grinding down the slight oval on the cutting edge so I wouldn't scratch the surface I was cleaning.Other than that it is a great tool, just know you may have to source some different bits depending on the work you want to do.

Very effective at scraping bark from sparkleberry for hand making canes. I used it to scrape the shaft/root to shape; remove inclusions like bark, loose knots or rotten wood; reaming cracks; and to get the twisty cane shaped and down to the final weight. That wood is highly figured, very hard, heavy and strong and the carbide blade did a tough job faster than the knives I have always used without the lost time for the frequent sharpenings tool steel requires. Replacement blades are a little pricey but each has 3 sides. I used the original side for about 16 hours before I rotated to a fresh side when attaining the point where I was doing finer work needing a sharp edge with better control. The old edge will be rotated back for the next initial rough work and I expect to get at least that much use out of it yet again.The only negative I can say is that the small (1" wide) blade can turn with inattention and the sharp point will gouge a groove across the grain. No problem in the initial rough stages but be on your guard when your are close to the sanding stage.Sparkleberry (or Farkle, Farkleberry) is a type of tall blueberry found all over the SE and is especially plentiful here in the Low Country of SC. Great places to acquire it here are old unused sandy fields being recleared for planting or for the sad future of becoming a subdivision. If you get there during the clearing operation, talk to the operator and he will usually not have a problem looking around and/or at his burn pile. With a little luck, you can get a 10' tree, in excellent shape, already ripped out of the ground but still possessing the beautiful roots which make a beautiful handle-- the only work left is trimming branches and cutting it to length. It needs to be dried for a year or so, out of the sun with plenty of ventilation, because it checks (surface cracks) when drying unevenly. The larger cracks, IMO lend character to the cane and are not apt to make it unsafe, just potentially imperfect for some people. The current specimen I am now making is ~7/8" in diameter and despite being a big man, I can not make it flex across my knee with a hand at each end pulling as hard as I canThis wood grows with a twisty trunk, not straight like an oak sapling, but winds up a flowing shape which when sanded to a glossy state (finishing with 0000 steel wool) and rubbed with tung oil, makes a beautiful reddish, or yellowish brown specimen with beautiful color and grain variations, especially in the roots and hard knots, that will be a unique, stable (I use one myself) eye catcher that will get a lot of positive comments.