Plasma Cutter, [Blow Back Pilot Arc][Large LED][Air Sensor] 80Amp Non-HF CNC bestarc Plasma Cutter Machine 110V/220V Dual Voltage, 5/8" Clean Cut 1.57" Max Cut, PA/PT, 2T/4T for Beginners DIY

I have been using this plasma cutter with Crossfire Plasma CNC with torch height control and it has performed flawlessly. Never had any kind of problem. It costs about 1/3 of other CNC type plasma cutters. It has external connections the Crossfire uses so I did not have to open up the chassis to make any.

Good Plasma Cutter for the money

Works awesome! Great value

Works alright for hand held. However, whenever I try to hook the torch height controller to it, it starts the arc very intermittently. So the only way to operate it cnc is to unhook the torch height controller and run it manually.Although the output pins say 1:1 for the torch height, the most volts I could get at the output pins is 5.4 volts (50:1)...

Bought the BTC500XP to use on a CNC table since my 500DP caused too much interference. This one works just as good as the 500DP as far as cutting, clean cut on 5/8" mild steel. Very impressive for the price.Only complaint, why not provide a 50:1 voltage output instead of the 1:1 they provide. Wouldn't cost much to add in a voltage divider. Plus, there should definitely be a cover on the 1:1 voltage output. Very dangerous if someone was trying to reach for the power switch when it's running and touches that output.

Talk about a badass lil unit cuts well beyond what it says it can. Perfect for every garage

This works great, has paid for itself many times over with jobs I've done with it.I bought another brand here on Amazon and it broke before completing the first job, have done over 200 feet of cuts now and this one is still going.No external dryer or separator needed super convenient and common air chuck and 220v plug...Never been happier with an Amazon purchase.

So far it cuts very cleanly on rusty and dirty heavy steel plate without any issue. I have not hooked it up to a table yet that's the next step. I own several plasma cutters but the price was appealing on this one. Is it as good as an American Lincoln, Hypertherm, Miller etc.. no.. it isn't (you can tell by the build quality and durability on the torch but those were 4 times the price)I have found the consumables to be way cheaper than any American brand. If your using it as a hobbyist or light shop use I think its fine. Availability of parts or service-unknown