Slime 2080-A Tubeless Tire Valves 1¼", TR 413 45, Schrader valve stem, pack of 2 valves

I had a leaky valve core and the valve tool worked great for removal and installation of one of the included valves. No more leaks!

I used the tool to remove a valve from a self- sealing tube, which had begun to leak. I was able to remove the valve and clean it and eliminate the leak. My only complaint is that the tool length is just slightly too long and this caused the removal and replacement to take just a bit longer. All in all, this is a nice, compact, helpful tool to keep in your repair kit! (Ironically, this tool is made by the same company that caused the leaking valve)

Works on go kart mini bike and small quad 6 inch rims and a great seal

It's very durable tool however with my spokes being so close together because they are 20x3.0 ebike tires, it's hard to turn the tool without it smacking against the spokes! But still a great value and a great price!

As described

Great Product - Great Price -

Worked like a champ replacing the valve stems on my John Deere LP21935 cart. I rated it 5 stars on "easy to install" because of the fact that it's not the value stem that makes the process a little difficult. It's the fact that it just takes grunt work and getting your hands dirty to get it done. Here's the basic steps I followed:1) Remove the wheel (hammer and flat-head screw driver to tap out the retention clip),2) Deflate tire,3) Use a 4lb hammer to "break the seal" (this involved smacking the tire until the bead broke away WITHOUT hitting the rim),4) Used a pry bar to separate the tire from the rim and position my hand behind the inner-valve stem,5) Use a Vise Grip to rip the old value stem out and catch the inner part and dispose (if it dropped inside I don't think it would matter since this is a low speed use),6) Carefully position the new valve stem into the hole from the inside (don't drop it like I did or you'll spend 10 minutes shaking the tire around until it falls out to try again),7) Use pliers to pull the new value stem through the hole until it pops into place. (Don't jerk it super hard or you might pull it all the way through),8) Reinflate. I didn't have to clean the bead or anything like that. It just sealed and is holding great,9) Slide the tire back onto the axle, ensuring you install the first washer, then the tire, the second washer and then the retention clip.,10) Position the retention clip into the groove with your fingers and then use the edge of a flat-head screwdriver and a hammer to gently tap the clip back into place.No fancy specialized tools were required for this job.It was so easy, I went ahead and replaced the value stem on both tires even though only one was bad.Hope that helps!

Well made, needed to replace wheel barrow wheels and I'm very pleased.