Vetroo AL800 Mid Tower ATX PC Computer Case - Door Opening Design Tempered Glass, Adjustable LED Strip, Pre-Installed ARGB & PWM FDB Fan in Rear, Support for 50 Series GPUs - White

GOSH I LOVE THIS!!! The case is super high quality and durable.. I actually dropped it when I first built my PC with it, all it had was a slight bend in the corner and all my internals were completely fine, still kicking to this day. I would buy this again and again

I needed a new case for my triple fan radiator. My old case was the same size but only fit a 2 fan radiator at the top. I had a choice between this and a perhaps more appealing to a gamer yet likely cheap materials at a higher price due to it's aesthetics pc case. I decided to go with this, and went from a black case to this white for the ambiance effect it has with RGBs. But what won me over was the extra fans. I figured I wanted beauty and performance over sleek faux futurism.I regret nothing! I installed 2 ARGB fans into the extra slots immediately, and replaced the fans underneath the GPU as well. Btw, YES they make a difference! My 2080ti runs noticeably cooler when gaming. They 2 under the gpu, the 3 front, and the 2 extras inside are set to INTAKE. Holy cow do they suck in air. The exhaust fan in the back is blowing cold air when it's running at full. There is only a little heat that comes out of the top radiator. The inside of this case is getting so much fresh air, it's just ice cold all the time.My old case had 3 fans but only had a narrow slot along the front, and on the bottom to draw in air. This case has the whole front panel to draw in air. Then you got fans along the side helping pull more air, as well as the bottom, and your psu also pulling air.THIS BABY IS A VACUUM... without all the loud noise.Downsides. The extra white fans aren't anything to brag about.Also the bottom has screws for 3 fans... However it's impossible to fit a fan in the middle slot with an ATX motherboard. All the case/usb and other wire essentials plug in and stick out. These bulky fans, and my narrower fans both fail to fit. They should have moved the mounting holes just a few millimeters towards the glass and it'd be perfect. Idk how they could have made such a great case. And then fail to notice such a flaw that is so easy to fix at the manufacturers level. I will eventually have to drill my own holes, but honestly I am not that picky. I just have an ugly gap between my fans. I 3d printed an icicle to hold up my gpu there instead.I am going to give this a 5 star solely because that extra fan doesn't matter, and out of an otherwise perfect case. I can accept one small flaw for it's price. If it was over $150 in price, I would give it a 4. But this is too good of a case for it's price for me to give it anything less than a 5.

This is an awesome mid tower case. It has magnetic side panels instead of the screws which made it east to access. All the ports are on top which makes them easy to reach. Has a mesh like material for front case air flow which was one of the things I was looking for. It looks very nice and check off all the boxes I had when I was looking for my case.

Wife loves it. White build inside with corsair pc fans really stands out. Largest, best pink case on the market. Although there is support for many fans, there was a lot of nuance to the sequencing of what parts to put in and where first compared to other parts to not have to re-work what you've already done. Took about 3 builds before I got it all into the case finally. Unsure if it is really full tower size. Yes, it fits a full tower, but it is way too cramped.

Nice case design, works as intended.

Love it! Great space, stays cool, Looks great! I'm running 6 fans + exhaust fan. My setup inside:MB: Aorus B650 Elite AXCPU: Ryzen 5 7600xMemory: 32GBCPU FAN: Cooler Master Hyper 212 Halo BlackGPU: Nvidia GeForce RTX 4070 XLR8PSU: Vetroo 1000 Gold

Great case and quality. Just a bit thin of chassis overall, but great case for any build.

I just rebuilt my gaming PC with this case and also bought 12, 120mm case fans.1. Case is VERY spacious, as you can see in the photo. Hyper 212 black CPU tower with 2, 120mm fans. AMD 6700xt 3 fan GPU from XFX. Both fit just fine!2. The back of the case has a good amount of space as well for cables. I have a non-modular PSU, the 12 case fans (2 cables ea), a hard drive, and 2 fan controllers tucked inside it.3. Tons of air flowing in this case, should have no issues keeping internals cool. With 12 of these case fans going, it can get a relatively loud wind blowing noise. I wear a headset most of the time so..4. The case is a fairly big size, I underestimated it based on pictures. I have a big desk so it's no issue for me, might be for others though.A couple things to gripe about.1. The picture on sales page is miss leading, it shows a kind of gunmetal grey front panel.. It's all black. I really wanted the gunmetal grey. But black looks great too so no worries.2. The product page also states up to 11, 120mm case fans.. It has up to 12, 120mm case fans. Luckily I bought 12 case fans. So worked out great!Overall it's a great case! I would easily recommend it.