BIGTREETECH Interface Cable Realize SKR Mini E3 V3.0 & SKR Mini E3 V2.0 Control Board Compatible with Ender3 V2 Screen

Seeing reviews of it not working- if you orient it correctly it works! If it’s backwards it won’t power on, if it’s upside down (white mark on bottom of pins) it won’t work. Just connect it correctly and it will work! This was just what i needed! Worked with 0 issues

if you are upgrading and ender 3 v2 with an skr mini from big tree tech, you need this cable to maintain the factory screenthat said, don't make my mistake and purchase it separatelyit is available as a package deal with the main board for cheaper

This review is for the BIGTREETECH Interface Cable (SKR Mini E3 V3 to Ender-3 v2 LCD)I purchased the SKR Mini E3 V3 when it first came out and love it. However, the LCD that comes with the Ender-3 v2 does not work with this board using the standard video cable. Fortunately I had a generic 12864 LCD which worked well. I recently found the BIGTREETECH Interface Cable on Amazon and ordered it so that I could return to using the E3 v2 LCD. Unfortunately, the cable is just too short. The original cable is about 50 cm and the cable that was shipped is around 30 cm. Additionally, the plugs on each end are not the same as the original in that they don't use a notch, which means you can inadvertently insert the cable backward. This fact is discussed in the product description on Amazon, but there are no instructions included with the product.I was able to confirm that the cable works by squishing it between the controller box and the controller box cover, and by removing the tool drawer that comes with the E3 v2. I upgraded my Ender-3 v2 by using several BIGTREETECH products and have been happy up to now, but this is disappointing.

Works as I planned, saw a review on the board and purchased it to quiet down my printer. It works great, was very simple to setup, just remember to label the wiring before removing the stock board. Mine came with the latest firmware update which was awesome, I recommend you check in your settings. This also ass the the option to add a new touch screen which is neat, but I wont go that route yet.

Bought this when I was looking to hush the motors a bit, had dampeners ordered but figured this would be a better option since I will be upgrading more later. This gives me a better platform to continue making upgrades. Swap was simple, just read and follow directions.

It's a good product but my screen still didn't work and my SKR about set my printer on fire everything's hooked up perfectly I triple checked everything and I was trying to put firmware on it I'll let it suck for a couple minutes on but my screen was still off and smoke started shooting out of the nozzle the SKR Mini e33.0 is now on the Shelf and I'm running my 4.2.2 board again.

Used it to run klipper and it was working amazing until I tripped on the cable and ripped the usb connector off the board

Updated my stock ender 5 pro mainboard to this board and it’s working pretty good, thinking about upgrading my tronxy x5sa to this board