6-Pack Slat Wall Panel with 2 Trims Wood Grain Slat Wall 96" x 6.2" WPC Slats 3D Wall Panels Grey Grille

Great material they look so beautiful on my wall

These panels are easy to cut to size even for the outlets. We used an oscillating tool to make the cuts for the outlets and a miter saw to cut the panels to length. We purchased outlet box extensions to bring the outlets out 3/4 of an inch to be in front of the panels. The small over cuts on the corners of the outlet areas will be covered by the face plate. It took about 4 hours to install since we had to figure out the outlets and we used the brackets and screws instead of adhesive. The trim pieces give a nice finish to the edges. Each panel has the wood finish on only 6” of each piece (not 6.2” as the .2” is a small groove that attaches the next panel). Keep that in mind when you are taking your measurements! We are very happy with the results!

Beautiful/easy diy/

Was nervous because the reviews were average at best so I safeguarded my bet by ordering these and the real wood ones from another vendor. These looked amazing, well packaged, easy to work with, and you get more of them for less money! I returned the real wood ones. They cut easily (I used a fine tooth hacksaw and did it by hand) and installed easily (I used construction adhesive), they fit together well and you can’t tell where they meet. If I had a complaint (and I really don’t) it would be that they’re kinda expensive for what they are but they’re worth it and look great. They are decorative only so if you want sound deadening or acoustic panels note that these are not that, it’s the same plastic/fiberboard material throughout.

This product - in the end - looks nice. It arrived with two of the ends smash. It suggests that you glue this but the back is smooth so it doesn’t stick with construction adhesive. I was able to nail this into place until the adhesive dried. However I needed to pre drill each time and use a nail set to fit between the slats to hammer in each tiny nail.Also the trim is yellow inside. While it is fine in the corners (where the trim lays flat against the wall panels) I cannot trim the bottom unless I want to yellow inside facing up (where the trim would cup the cut ends.) They also do not have end pieces so the end of the trim is also yellow.This can be cut with a chop saw to needed length and width (our run ended on a half section.)

Great product, easy to put them up on a wall and looks great. I only encountered a few problem some of the panels back were damaged slightly and shipping took close to a month. End product looks great!!!

It came damaged. I am dissapointed but will try to make it work.