M8 X 1.25 Metric Hand Tap, Right Hand M8 X 1.25mm Threading Hand Tap 1Pair

Had a broken one this should replace it haven't used yet though

Good quality product.

Works great! My only gripe is that the shank is really small. Half the size of my snap-on. Which made finding something to help turn it pretty difficult. Ended up using an adjustable wrench. I used the tap to chase some threads on my intake manifold so it’s not like I was making new holes.I recommend the seller linking a tool with these taps to turn them. For the money spent on these it’s a no brainer to give them a try. They worked well for me with cast aluminum.***In my photo the broken tap is the SNAP-ON tap. I put them next to each other for size reference of the SHANK.***MY TAP FROM THIS REVIEW DID NOT BREAK. That’s the one I replaced with these!

Need to tap a hole? Look no further than this fine and dandy item. Yes, you too could be cutting a grove that any machinist would be proud to call his own. Don’t have a hole to tap? don’t despair, you could use this as a really fancy corkscrew. Just drill a hole into a cork, tap out threads with this handy tool, insert the proper bolt, grip with a vice grip, and voila, you can pull out the cork with greater confidence and aplomb than the most snooty sommelier.

Worked well.

I was a bit concerned about this little specialty tap due to price and country of origin. I was wonderfully surprised. First use was threading a small part made from 304 SS. Cut through it like butter. Great little tap. I haven't used it alot yet (other than in Delrin) so I'm not sure how long it will last, but out of the gate I'm really pleased.

worked as expected. The picture led to think that one of these was a bottoming tap, but they were both the same. They worked well for what I needed.

These two taps cost less than $3 and include a standard tap as well as a bottoming tap, both are very nice quality. Very sharp and easy to use.