SELTERM10pcs 1/0 AWG - 5/16" Stud - Battery Lugs, Heavy Duty Wire Lugs, Ring Terminals, Battery Cable Ends,0 Gauge Terminals, UL Bare Copper Eyelets Electrical Battery Terminal Connectors

I was worried the inner diameter would be too small for the 2/0 welding cable. Plenty of room putting the stripped cable into copper. I pack my fittings with grease, then put the cable in. The grease prevents corrosion inside the lug. I live in the northeast.........salt on roads, corrosion, etc. Former chief engineer on an ocean going tug......saltwater=corrosion. Add in heat and electricity and oxygen in the air and you have corrosion. The grease displaces the air within the fittings and strands of copper. Also helps to prevent moisture/water migration between the strands and outer rubber insulator. I used a hydraulic crimper that I purchased on Amazon years ago......nice tight fit. Then I put shrink tube over the finished crimp.All in all..........nice lugs, cheap money..........certainly less expensive than the welding store!!

I needed to make some cables and they did the job. A good crimpers made these look like a professional job. Just make sure to use with 2 gauge wire and you should be good to go.

Made well

High quality, easy to use, crimp or solder.

Well made product

Accurate order, reliable service, fast shipping. Third time using Selterm.

They work as intended, no complaints. Would recommend for the price and got to me faster than ordering from the box stores.. Apparently no one local carry’s the crimp style, only bolt in.

This is virtually the same quality that I would expect to receive from an electrical wholesale house.

Did what it was supposed to do. No complaints.

As described.

i like everything about lugs can be cripped and soldered or both

Have not used them yet but look to be very good quality

Good