Small Parts 0203FPP410 410 Stainless Steel Thread Cutting Screw, Plain Finish, Pan Head, Phillips Drive, Type F, #2-56 Thread Size, 3/16" Length (Pack of 100)

perfect for doing custom hot wheels work

Gone through a few hundred of these screws now, and I'll keep buying them.They're great quality steel (rarely ever get stripped), and they're magnetic (unlike stainless).It took me 100+ wheel swaps & fiddling with various drill bits, taps, and screws to figure out these particular screws are absolutely perfect.1st, I was wasting a lot of money on #52 drill bits & taps that BOTH KEPT BREAKING (PLUS the time it took to keep switching bits).These screws are slightly thicker than other precision screws listed under the same size... BUT - it turns out - they're PERFECT SIZE for holes drilled with 5/64" impact driver bits (Milwaukee Red Helix = way harder to break and last 20× longer).Getting an extra 1-2 mm down into the rivet pegs takes 5-10 secs longer (with the Red Helix bits PLUS EXTRA CARE TO NOT DRILL THRU INTO MY HAND 😅).... but the amount of time I save without the extra step of thread-tapping is now totally cut out.

Perfect para hotwheels

These 410 Stainless Steel Thread Cutting Screws fit perfectly for the task I use them for. I use them to replace the post rivet on the bottom of hot wheels cars after I rebuild them.

These work okay for closing up 1/64 bodies. Good size but the material could be harder or stronger. Although self tapping, you really need to drill a pilot hole deep enoug, otherwise the screw head can be prone to breaking off the shaft if not careful in amount of torque applied.

Perfect

The screws are perfect and look nice they fit perfectly under the hot wheels, as long as you make the whole big enough for the screw to fit and go all the way in they fit nicely you just have to know how do it that’s the most difficult part but overall the screw was good nice finish on it also.

Drill the rivet, disassemble, replace wheels and reassemble with these self tapping screws. They’re magic.