First4spares Main Rubber Door Seal for Indesit and Hotpoint oven/Cookers

Ideal, our last oven door seal had separated at the bottom center and I could not, for the lift of me, get the two ends attached again. So, quick browse one the biggest shop in the world and I got this, it arrived promptly, I took it out of the bag and let it sit on the table for an hour or so to let it unravel, then, removed the old seal and put this one in, fits nice and snug but no need to worry about stretching to get it to fit, it's simple, just line up the metal clips with the holes and that's it. Easy peasy, lemon squeezy!

As good as if not better than the original, fit my hotpoint hub 61 perfectly.

easy to fit

Purchased this to replace rubber door seal on Logik LBFANX14 oven. Although, the seal is not an exact replacement it does the job perfectly. So simple to fit. Just remove the old seal and this seal has a metal clip on each corner that stretches the rubber and clips into place. Took less than 5 minutes to sort. Thanks.

This product is not compatible with Hotpoint oven as described. The attaching hooks are positioned incorrectly. I've had to return as it's completely useless.

I am very pleased with this product. The old rubber seal on my Indesit oven had perished, and needed replacing.I wasn't sure whether this would be right, but for the price, I decided to take a chance.It fits perfectly, and it forms a good seal - I am delighted with it. The rubber seal was supplied, complete with the fitting clips/hooks already in place.If you are wondering about the size, I have measured my oven doorway.The actual HOLES (where the clips are hooked in) are 450mm apart along the top and bottom, and 365mm apart down each side.There also is a bit of stretch in the seal - it fits my doorway perfectly, but I also think that it would have fitted a slightly smaller, or bigger doorway.If your doorway is larger than mine, (in my opinion). it would probably stretch another 3-4cm bigger on either the sides or the top, but it might be pushing it to expect the full stretch for both the top and sides at once.If your doorway is smaller than mine (again, in my opinion) I think you could probably get away with it being up to 2 cm smaller on either the top or the side before it started to be floppy and unfit for purpose.I hope this helps

I bought this because it said it was the right product but it wasn't the right product, I bought it and I didn't fir properly so had to buy another

Arrived quickly, easy to fit and does it's job!!