IwataMedea Nozzle Wrench

This tiny wrench is one that you will definitely need if you own an airbrush.Very well made.Very easy to use.Easy to store away for when you need it again.Well worth the money.

Excellent quality!

A far safer way to remove and install airbrush nozzles, this doesn't prevent you from damaging your airbrush, but it makes it a lot harder. I don't think I could ever go back to the little stamped wrenches that come with airbrushes after using this thing.

It's good. I'm not sure that it's worth the $$ for the small nozzles on the "generic" paintbrushes. It works. But I end up fumbling around to get the nozzle to nest into the wrench. I could just use one of the little stamped wrenches and have just as much success. The tiny nozzles don't nest into it perfectly... the slot in the wrench is too wide. Maybe works perfect for Iwata nozzles??? I understand it is their brand. Lol.

Solid and well made, fits the iWata Eclipse style nozzle tips and similar clone tips. Greatly reduces the risk of stripping the tip when changing them and lowers the risk of sheering said tips from over tightening.

It makes it really easy to take them off and put them back on without overtightening. One of my goto pieces of kit - way better than the stamped wrench the brushes come with

Must have for airbrush nozzle removal. MUST!!

The Iwata nozzle wrench fits my GSI Creos PS-290 perfectly. Of course, the first thing I did was drop the nozzle on the floor of my garage... I'm going to call this tool a must have. Also, it really should come with the airbrush instead of that little wrench. I knew not to over tighten the nozzle with the flat wrench. However, when I used the Iwata wrench, I could barely get the nozzle to turn because it was so tight. So, lesson learned! You need this wrench!