AP Products 024-1004 LP Tank Check Monitor Silver, Standard

Fantastic item very helpful. Thanks

Makes a nice addition to the application. I mounted this above our stove because sometimes you just want to see how much propane you have. The app is obviously way more accurate but this gives a great reading too. Setup was simple. I bought used - like new, which was missing directions and the screws. It was super easy to figure out. I used sticky Velcro to mount it in case I want to move it. Super easy to use and install

It was easy to set up and it appears to be as accurate as the reading I get from the app reading the seniors on the bottom of my tanks. Mount it by your control panel and you don't need to worry about running out of fuel again.

Works really well and very convenient

So I bought this to use the sensor, after syncing it showed almost empty on a a tank that I knew was almost full. Downloaded the app and it shows 63% full.....

I bought this for my camper because I had a hard time figuring out how much propane I had left. It is rough finding out that you ran out at 2am when it was 32 degrees outside. Since adding these to the bottom of my tank I can check with the push of a button. So far it is pretty accurate. I knew my tank was empty and it read empty. Had them filled up and they read full. Ran the heat for a couple nights and the level shown was right where I would expect it to be.The only issues I have to say is that the spacers that come with it did not stay on very well when I removed the tanks to get filled up. Also, since the sensors are magnetic and has to stay in the middle of the tank, I added a piece of duct tape to make sure it doesn't move when handling the tank or driving to the site. Love these.

I use this on my RV to monitor the 2 x 30 LB propane tanks. It makes it so much simpler than having to remove the tanks to judge how full they are. I had used a single Mopeka sensor on my other camper that had a single 20 LB tank, and just used the free App for your phone. After upgrading campers, I felt it would be simpler to install this display in the compartment near the tanks. So far, I have to say it is a winner!

I had high hopes for these as I'd prefer not to keep track through my phone. I normally like to check the tanks before I'm going to do a big cook or just before a shower on a cold night. At first they worked perfect. Paired with both sensors no problem. Did a test on both tanks. I know 1 was full and the other I'd been using about a week. Levels looked correct. Well, last week I went to check levels and they both showed 100% full and I knew that wasn't right. #1 was out and I was on #2 tank and that should have shown 70-80%.I went to reset and pair them again and they refuse to work. Switched sensors around, tried pairing and no matter what all I would get is full blinking lights and if I pushed it would go to 1 red light. I even got the instructions again to make sure I wasn't forgetting a step or something. Same result every time. Got so frustrated with it I'm just done with the whole system now. For the money you pay for the sensor and the meter I expected way more use out of it. It was great when it worked but if I can't rely on it it's not worth my money. I'm just going back to the old fashioned way of doing things.