Auxbeam H4 9003 HB2 P43T Canbus Error Free Anti Flickering Resistor Decoder, 2pcs/set Enhanced Decoder Canbus Drivers

Have a 2016 Jetta Sport, and replaced my headlights with Lasfit LEDs. Unfortunately, they trigger a light warning on the dashboard, but after installing these decoders, the light hasn't come back on again.

So, i got these to help fix the flicker and error code my recently purchased led bulbs were causing on my 2017 Mini Clubman S. After i installed them, i noticed the flicker was much less, but still there. Then, once the car was switched on, the high beam error code reappeared.The manufacturer of my bulbs sent me a message through Amazon that their bulbs worked in 99% of the vehicles without an issue, but, if i did experience flickering or error codes, simply reply to the email, and they would send me the canbus harness at no charge. I did just that.Think about this: the system in your vehicle is looking for a certain amount of resistance in your bulbs. If it doesn't see it, it throws an error code. Each bulb across different manufacturers will likely have different resistance values on their bulbs. They make the canbus adapter to compensate for this difference between their bulb and what the vehicle is looking for. If you mix manufacturers devices, your resistance can still be off, either too much or not enough, still causing error codes or flickering.Lesson learned: if you need the canbus adapters for your vehicle, get them from the same manufacturer as your bulbs. It will probably work correctly.

Plugs in like w your lights... Super easy install and it actually fits in the light housing so I didn't have to drill and caulk my light cover as shown in many YouTube videosWorks good and I'd rather spend 20 bucks and know my lights work than have random issues later2015 jeep Cherokee

Connectors didn't have gaskets and didn't secure to bulbs. I had to buy different ones. BUT...customer service was very friendly and quick. They did apologize and refund the price as well as helped with a replacement that worked. Produce 2 stars, customer service 5 stars!

I bought this for my 2005 Dodge ram 2500 I was extremely happy with the headlights when I bought them other than the fact that they flicker when they turn on when I go from a high beam to a low beam they shut off for anywhere from 20 seconds and one of them will turn back on and then up to 2 minutes until both of them turned back on sometimes longer so I bought this in the hopes that it would fix that and I have not even been able to find that out their customer service has been an absolute joke I've been in contact with them for 6 days now not including the Sunday that they're closed they are only open at what is my time 6:00 p.m. And when I try and call them at 6 or 630 ish it goes directly to voicemail Open till they feel like answering at what is about my time 9 o'clock And then once they finally pick up and find out that I have a real issue that it's gonna take work to get to the bottom of they don't respond on the phone they just sit there and do nothing and then once I get frustrated with that after 5-10 minutes or so and start asking for their manager they put me on mute If they decide not to do that they're blatantly disrespectful and couldnt care less about helping me with my issue So I just hang up because there's no hope of getting anywhere I am severely disappointed if at all possible I would give this negative stars The worst thing about it all is their headlights actually do perform well but the way they treat their customers is beyond disgusting I'll be removing anything with ox beam from my truck and that sucks because all of my light bars and everything are through them but I will not support their company after this and I'm gonna tell everybody the exact same thing

Installed the B07YQK1TZZ for the Low Beam Headlight on my C5 Corvette. They say “Fog Lights” but according to Auxbeam they can be used as headlights but you must install them correctly. With the Canbus in the cord plus I also used this “B01N2OI1KN Auxbeam 9005 9006 9012 LED Headlight Canbus Error Free Anti Flickering Resistor Decoder” the “Twilight” option works fine, when you turn the car off the lights will turn off after 2 minutes but the Head Light Doors WILL NOT close. When you set the emergency brake, turn the car off, then turn the Headlight Switch on then off the lights go out and the doors close. It sounds like a lot of trouble but with the LED Bulbs this is the only way I could find to make everything work on the Corvette.

When I went to instal product I thought I was the stupid one putting it on wrong and not matching the terminals together..but turns out they’re backwards..kinda strange but they work. The socket for where the female end meets the male end to the lights was too deep *on the decoder end* so I have to cut the end of it by 1/4 inch. But product does as listed.

It took about 2 days and the flicker came back. It was like the install never happened lol. Connectors are bare so I'd suggest using a self adhesive, high temp tape to create a seal at the connections. Connectors wouldn't line up right and I had a hard time getting it to fit. I fiddled with that a lot. After all that it just didn't work. I gave it three weeks to see if it would just start working but I've returned it. I used it on a Volvo 240. When it did work it was great but it didn't work majority of the time. I've used another brand since the return and that one works great. I would not suggest this product.

Buena calidad y precio

Only worked on High beam and flickered off and on on low beams

Bought this h13 9008 decoder harness to pair up with auxbeams fs3 series led bulbs due to the bulbs didn't come with decoder in the kit . Plugged everything together turned the truck on , high beams work with no problem and the low beams flicker a few times then shut off completely. Both brand new components and it doesn't work at all , not happy with the product what so ever ,and plus now I am out 30 bucks for decoder that doesn't work and around another 50 bucks for the bulbs I purchased and flickered right off the bat making the whole kit un usable

Great

It did not solve the issue of flickring and toruning off. Does not work with dodge ram.