50pcs 12 Volt 5mm Warm White LED Lights Emitting Diodes, Pre Wired 7.9 Inch DC 12V LED Light Diffused Colored Lens Small LED Lamps

I am very impressed with the quality.

The bulbs work great. The lenses are diffused just right to spread the light. Got so many that I’ve given away half of them. Great value.

I am very pleased with my purchase and service

The media could not be loaded. This is a nice set of LED's. which LED lights last longer that other typical small lights. The LED bags show the wire color to identify the Cathode and the Anode when wiring. So pretty straight forward and can be used on any project you have going on to add lighting.

ok

The media could not be loaded. FOR THE RED AND BLUE LEDS:For a simple LED light box these flashing LED's perform very well. I choose to use the 5 volts from a USB power block for power. The brightness at 5 volts is more than adequate and with operating at this lower voltage, the expected lifetime is greatly increased as they are operating with a reduced voltage....

Loved these, used these, job done

For some electronic projects around the house, with varying voltages from 5VDC to 12VDC, I would like to have some status lights included. These LEDs fit the bill nicely. Although the leads are around 30 gauge (measured 0.31mm thick on the tinned ends), their 7" usable length is plenty. The first 0.8" is the heat shrink around the built-in series resistor so if you have a shallow mounting place, be aware you'll need about an inch below the base of the LED to route the wires. Intensity is quite good even at 5V - tested with an old cell phone AC adapter rated at 4.9V. Current draw at 5V is about 5mA when the LED is on. Items arrived in a thin, long cardboard box, inside what looks like an antistatic ziploc bag. Quick count seems to say that there are 52 LEDs in here.First use will be in a project I'm doing to convert a battery operated only device to allow normal use of an AC adapter but fall back to the battery pack if AC power is lost. A coaxial power jack and a relay is all that's required, along with a bit of re-wiring of the power leads inside the device. The LED will flash whenever main AC power is off. I know that using a flashing green light to indicate a loss of power seems to go against more logical choices (red, yellow), but I chose green for the brightness over those others. The device already has a built-in flashing red LED to indicate low battery so that's another reason to go with green.