Deck Rebuild Kit Compatible with Newer Craftsman 42” Models LT1000 LTX1000 Compatible with 2 Spindles 130794,1 Idler Pulley 131494,1 Idler Pulley 173437,2 Blades 134149, 1 Belt 144959

The product fit 100%. At first I had my doubts because the new tower bearings are a three bolt whereas the ones on my mower are four bolt, however my deck was drilled to except three or four bolt bearing towers the only issue I really ran into was the bracket for the break spring I ended up having to grind out one of the holes so it could sit properly. So overall great deal for the money!

Spindle's lasted one hour, before started screaming and locked up!

Bad vibration from day one. Couldn’t isolate it until it had enough side play in shaft to start scalping the grass. Very dissatisfied. Should not happen.

Good quality parts did the job! Blades are ok, only sharpened at the ends. OE blades sharpened from the tip 2/3 of the way toward the center.

Everything fit. Mowed for about 30 minutes after install. No issues yet. Will give it a good test in about 2 weeks and will review again. Only problem is one bolt broke inside the new spindle. Had remove the broken bolt and use one of the old bolts. It is a different size socket, so it just doesn't match.

mowed several acres with good clean cut, if it all lasts a couple years it will have been a super deal.

Not sure why others gave it a bad rating. I have only mowed once (0.8 acre) since installation, but it cut like a new mower. Idler pulleys are tough to install, but that is due to the deck design, not a fault of the parts provided.

Didn’t come with blades and the spindles are made of a lesser metal cast than the OEM. One of the ears the bolts go into snapped off one of the spindles.