BIQU Panda Jetpack for Bambu-Lab P1S P1P X1C X1E, Front Housing Assembly, Print Head Front Cover+Cooling Fan Duct, Larger Air Flow, Effective Cooling, Compatible with Stock Extruder and Panda Revo

Firstly, this is a very quick and easy swap for those who are scared to do this upgrade. I do like this as an upgrade to my X1C and I really only have one complaint about it. The magnets on the bottom of the fixture just are not up to quality, they are either poor quality or just too small and they really provide little to no magnetic attachment and this relies almost fully on the top magnets. If you print with 300+ mm/s or 15,000+ acceleration, there's probably a good chance this will just fall off mid print ( I have yet to have this happen though i print lower speeds ) Regarding build quality, this almost looks 3d printed, and might be. But it doesn't feel like it will break from light force. The logo is nice to see when lit up I have noticed some /slight/ improvements in my overhangs, but i feel like most of the improvement to this for me is when I have short layer times, it has noticeable helped me on those prints! Happy printing! :)

Looks cool, but the quality isn't there. I've seen people mention casually about the Panda Jetpack popping off the toolhead mid-print and always found the claims suspect. Well, to the folks I doubted, I apologize. I cracked open the box, everything LOOKS great. I proceeded to transfer the fan and circuit board over without too much difficulty and reconnect to the toolhead. Here's where the problem comes. The fit isn't there. You can only get 3 of the 4 magnets to make contact at a time. So, even if a small amount that I couldn't detect with the naked eye, this thing is warped enough to not allow for correct installation. I'm betting that the folks who have these things falling off may be able to blame this same quality issue.

I don't know if it's because it's not a perfect fit to the printer head or it doesn't attach quite the same way, but when the printer is moving the head around (which is basically all of the time when it's running), this housing causes a peculiar buzzing noise. I've checked all the screws and attachments and everything's snug, so I'm not sure the cause.

OK, easy to install. One of the magnets was glued in properly and came loose within a few prints and I had to glue it back in myself.

Just received today, as soon as I opened it up, the part of Honeycone shape was already broken half, the case its very soft, not a good quality. Please see the picture and on the lower left of the case.

The unit is supposedly lighter than the stock X1C cover, and advertised airflow improvements. I haven't noticed any major change, but I went down the Biqu product wormhole (I've purchased almost all X1 upgrades) and it is what it is. I'll edit review if anything changes

I had high hope for this. The magnets don't seem strong enough and the plate keeps popping off. At one point I had a buildup and one side of the vent melted. BiQu was not helpful in discussing the situation.

These have 4 ports for air to flow through and these are known for being clogged. 2 of my 4 had restricted airflow. I'm sure it works great if all 4 are open. Make sure your ports are freely flowing air before installing