Bringsmart 370 Mounting Bracket with Screw Worm Gear Motor Fixed Fastener DIY Parts DC Motor Holder (Single-Side Bracket)

It’s a fine bracket but it doesn’t fit Greartisan DC 12V 120RPM Turbo...

I'm using with Greartisan 8mm gear motors. Perfect fit. I used the M4 screws; haven't used the M3 screws.

It is a great motor bracket and I would order it again if I had that size motor to mount. Unfortunately, I couldn't use it, due to not being the size for the motor I'm trying to mount, although it was a recommendation by Amazon to use that bracket. I'll have to look closer before ordering the next time.

Headline says it all. It's just a bracket, but a good one

It was a little hard to get the mounting brackets to line up with the motor and get the screws in it they need to sell the connectors that go to the back side of the motor or have wires sticking out whichever is easier for them I'm not the great at soldering wires and I cannot find connectors small enough to fit on the back of the motor but if the company is reading this if you do make those connectors they connect to the back for the motor send me an email

Works good

A must have bracket useful for mounting the motor

I bought this thinking it would be worth it to not spend the time to fabricate my own. In retrospect, I should have done just that… the holes don’t line up and I needed to dremel the holes to align. The supplied screws with captive washers aren’t long enough to thread into the gearbox; there is 4mm of threads and the bracket is 3mm thick. I thought, I’ll just remove the captive washers as a workaround, but no-go, it will just wreck the threads on the screws that are made out of pressed cheese. I had to go pick up M3-.5 x 8mm screws. A huge waste of time, obviously I’d rather have made my own and avoided the cluster.