3M Professional Grade Rubberized Undercoating, Corrosion, Water and Salt Spray Resistant, 03584, 16 oz. Aerosol

good stuff looks good and goes on easy.

I have used about 8 cans to spray the underside of a 40 Land Cruiser. Comes out like a liquid tar but dries to a pliable mat finish. I applied it over a primer used multiple medium coats. Stuff is messy and goes everywhere, so make sure you mask off where you don’t want it. Lacquer thinner works well removing overspray but keep in mind what is under it may be effected as well. Make sure you clean the tip when you are done to avoid clogs. I did notice sound reduction ( less tinny) where it was applied.

"The perfect combo for harsh winter conditions! Living in a snowy area, rust is a constant battle, but spraying the Rust Reformer followed by the 3M Rubberized Undercoating creates an unbeatable protective barrier. Couldn't ask for a better shield against snow and road salt!"

Sprayed it easy, but I’ll have to give it a little time to see if it actually holds to the frame and for how long

So far I am Very Happy with this rubberized spray on protective product. I mean, it is made by 3M so you can't go wrong with a brand that has been so well established. I have ALWAYS appreciated 3M quality.

I know this is supposed to be UNDERcoating, but I used it OVER instead. I wanted rubber texture for various hand tools, yet did not want to spend $60-$100 for a good set of cushion gripped screwdrivers and such. So I set out to find a way to apply decent grip to a tool without ruining it or adding excessive bulk, like with some grip tapes. My first test piece was a wooden handle to a sink plunger that was collecting dust. To judge the adhesion quality, I did not roughen or prep the surface in any way besides wiping with a wet cloth to remove the dust. I carefully sprayed a small amount on opposing sides of a 6 inch end-section of the handle, spreading it with a small paint brush. After I was satisfied with the applied thickness, I began to stipple the surface with the tip of the brush for texture. After 24 hours of set time I tested the surface for results, and was happy with the results. The texture provided good traction without noticeable bulk, as the coat was barely thick enough to hide the wood handle color. I then began to twist the grip in my hand with light-firm grip pressure, trying to rub off the surface, and had very little specs of texture come loose. I accounted for stippling surface rise, lack of surface prep and amount applied, and felt the makeshift grip was more than adequate. Next, my guinea-pig-screwdrivers: A USA made Craftsman set I got on Black Friday a few years back, which were very cheap so I would not curse the sky if I were to ruin them. The handles have parallel panels, all of which are smooth plastic. I lightly roughened every other panel with sandpaper, cleaned off the dust and applied the same way. I varied the design on 3 different screwdrivers for fun, yet they all work just the same. They are still holding the grip after MUCH use, from automotive to normal building construction use. I plan on doing a few more when I can get in the garage. Note: Take precaution for over-spray because this stuff can be messy. Also, when sprayed at close proximity it tends to bubble on the applied surface. Lastly, I do like this product for more stationary grips, but don't believe it will hold long on something equal to a baseball bat grip. If somebody tries that, please let me know how it turns out on that kind of aggressive surface.

Easy to use quick drying

REALLY WORKED GREAT

Wow bon produit jle recommande fortement je viens d acheté une acura et jvais metre une couche de ce produit sous le suv Photos à venir jle conseils forte et donne une belle apparence en dessous du suv regarder le avant et l après

Good

good

Awesome product

3m c est la qualité, bon spray épai et collant meme sur la rouille.