HitLights Dimmable LED Driver Transformer 24V 150W, Magnetic Power Supply 120VAC to 24VDC, Compatible with Lutron and Leviton Dimmers, for LED Strip Light, Kitchen, Cabinet, Class 2, ETL Listed

I bought this to power and LED strip light I used when remodeling our guest bath. I needed dimmable and this did the trick. Everything was pretty straight forward and it seems to dim very smoothly. It has been in use about three months now, but it is in a guest bath and has only been used a dozen or so times so I can speak to durability. It certainly seemed well built and solid.

Hit light products get the job done, super smooth dimming, no humming, no overheating.Great product

I erroneously ordered this 24V/40W dimmer in April 2018 and it worked ok, but flickered on/off at highest dimmer switch setting, and got extremely hot at the lowest dimmer setting. I contacted customer service in early 2021 to replace with the 12V/40W version for my under cabinet kitchen lighting. I sent this back and they replaced with the correct one at no charge. Awesome service.

Was not compatible with customers smart dimmer. They had a Brilliant smart dimmer and it wouldn't allow the driver to dim. If you have a smart dimmer, you may not be able to dim your led lights with this. I paired this with led tape and had to return it for an electronic low voltage (ELV) driver. Other than that, solid and heavy product that I'm sure would work fine otherwise.

Easy to install, worked great for ~2.5 months, but just failed this evening. The Hitlight LED strips I had this driver attached too suddenly went "out" and got very dim and are flickering. When I turn it off and back on there is a brief flash and them back to very dim flickering. The driver appears to have failed less than 90 days from installation which is very disappointing considering the cost of this driver.

This thing is solid and has been reliable so far. It's very heavy and needs space to vent, so make sure you know where this thing is going to be installed. It can't go somewhere excessively hot which might mean the attic is a no-go.It does flicker at the lowest setting, but not too bad.

Your product is expensive and aside from the case doesn't seem to be any different than your competition. I have ordered 3 of your transformer / LED power supplies; have installed 2 replacing my original competitors LED strip light power supplies which seem to fail in about 60-90 days. I replaced my old 8' florescent fixtures with 3' LED strip lights and they are great when they work, but spend a lot of time flashing or not working at all. One of your transformers is passing the 60 day mark without a hitch; so far so good. Your guarantee is what drew me to your product and I hope I never have to test your claims. Thanks so far. Walt

I needed the powerful power supply to light the double row LED strip to light the entire room almost. So I had to get this driver. Only problem is that this driver hums and buzzes. It sounds like piezo characteristics of ceramic caps used in the device. I wish they didn't use the class II type ceramic caps; they always buzz. And the MTBF for the component is not that great either. They lose the insulation resistance due to DC aging after five years. I am thinking about opening up the driver and replace all the caps with the film caps. They should have thought about the buzzing at $200, they need to do a better job designing the power supply. Stop using ceramic caps.