YYCKE 28mm High Performance Exhaust Muffler Silencer Pipe Assembly kit 90cc 110cc 125cc Dirt Pit Bike CRF50 SSR Baja Coolster Piranha Pister Pro Taotao 125cc TTR Taotao DB10 DB14 BMS pro 70

CHEAP AND CHINESE.... PERFECT FOR 56 BUCKS. installed on a ct70 clone. had to build a custom mount. sounds like a modern big bike.

Mounted right up to my Z50 pitbike. The sliding muffler clamp allowed it to mount up to my bikes original mounting points which helped alot because I installed a 110cc engine into it which made mounting the factory exhaust not possible. Little loud but better than straight piped and has a large diameter which is good for power. Came wrapped up and packaged nicely. Chrome had plastic on it to keep scratches off until after installation is complete. Careful with the exhaust manifold flange. It can bend if over torqued

This is a very inexpensive pipe and muffler for Honda trail 70s and CHI-NA Clones. Header pipe fits and has adequate clearances. Comes with new copper oring for header/cyl seal. Full length heat shield works well as it is very close to your right leg while riding. Muffler only slides on to the tail pipe and relies on the included clamp to be fastened to the frame so it is secure. On my trail bike, I had to make a simple "Z" bracket out of 3/16" steel so the clamp could be secure to the top shock mount stud and be positioned correctly. Muffler does have an integrated spark arresting screen at the end cap and this system is very throaty. No more stealth riding as its a through flow design but it does sound good, unlike straight a pipe.

Fast shipping. Finally was able to put exhaust on bike and it fit like a glove. Great product. Thank you.

The dimension for the part of the pipe that goes into the muffler was listed as 3.3cm, that is what I needed to use the muffler that I wanted to use. When I slipped it into the muffler it was super loose, so I measured the pipe and it was 2.8cm. Sending it back.