Sand Blasting Hood Cap, Canvas Shawl Sandblaster Protective Gear Mask Anti-dust Hood for Spraying Sanding Cutting, DIY Painting Woodworking Protection

its good quality. it fogs up fast. it needs airs supply. use a strong mattress pump and 3/8 tube. i had a long review and a video and amazon shot it down for who knows what reason...

This media hood works swell. Snug fit where it needs to be. Good vision and fit. You definitely will want to attach a low pressure air supply to the port provided for positive pressure to prevent fogging of the lens

Hood works great but the size leaves your nose touching the front if you have a normal to large size head.

Hood did a great job keeping the sand out. The one ting I was unable to do was to supply a good source of air inside if the hood and never was able to stay inside of it for long periods because it became stifling. Not the fault of the hood though as there is a nipple supplied to attach an airline. Just gotta get setup right. Fortunately my project wasn't huge. the

Excellent, make sure you kook up the air hose in the back of the hood 😉

This thing rocks just make sure you have enough supplied air coming in or it will fog up in more humid areas. Great hood.

Venting needs to be a it better and I’m skeptical of the front valve that is currently installed. I wear a particulate mask on the inside of this hood and have to use a no fog solution on the lens so it can go past 10 min without fogging up. That’s usually enough for the work that I do, but if you need to wear it longer, please be aware that you might be sweaty after taking it off

Works great if you don't want to fog up hook up air to the back barb fitting and your all set

Works.

cumple al inicio, te ayuda a protegerte de ciertos gases pero con el paso del tiempo cuando me lo pongo se empaña demasiado, no es posible ver, no se a que se deba pero al inicio funcionaba perfectamente

Good quality, but you need some sort of breathing apparatus. I struggled for fresh air, would have to hold the exhaust valve to my mouth to expel CO2 and water vapor (would fog the glass easily too). There is a nipple on the back of the hood (presumably for forced fresh air) but for my application that was not possible. Eventually I had to abandon the hood in favour of a full face respirator

Good hood. Will not fog if you use it with forces air. It shows glass but mine was acrylic and shot in 2 hours.

Pretty good at keeping out particles, but always fog up on me.