hykolity 18 Inch LED Round Flat Panel Light,32W,3200LM,3CCT | 3000K/4000K/5000K CCT Selectable,120°Beam Angle, Dimmable Edge-Lit Flush Mount Ceiling Light Fixture - ETL Listed,White

Good quality light. Offers three light settings (warm, daylight, bright white), is extremely easy to install and is a fraction of the price of lights at the big box stores for the same quality.

Bright and easy to install. Looks decent as well. Just hoping it lasts for a long time

It's a beautiful light and was a easy to fix. I am happy with this in our kitchen.

I needed a bright light for a utility room and this perfectly met requirement. The light is very bright, especially on the default setting. The lights they replaced have two switches configured to allow either switch to turn on/off the lights. Consequently I specifically did not want a smart light. I had no problem screwing the adapter/base plate to my existing ceiling boxes; the light itself then twists into position on the adapter plate - dead simple. Light is very bright, very even, no flicker. Exactly what I needed in my utility room. My only complaint (and it's very minor) is the wires coming from the light - they use thin, stranded wire and wire nuts. While many people consider this to be the defacto standard, I'm finding more and more units come with fast-install wago or push-in connectors. Wago accommodates stranded wires however I decided to solder the wire ends and then use them with push-in connectors (which I had on-hand). So aside from the anachronistic connectors, a great experience. There's no turn-on delay, and likewise turn-off is instant. No fuss lighting!

Quality light. Very bright. Pretty. Works as expected

Lots of light. Perfect for my kitchen. It was easy to install.

This light is very attractive, it's very thin, very minimalist. It has a nice bright white finish, and the bezel is exactly the same color as the lens giving it a very nice monochrome look. The metal back plate makes it feel much higher quality than many competing products. The chain is a nice touch and makes installing the light solo much easier. I found initial installation to be very easy, didn't need to shim and had no trouble pushing wires through the hole as other reviewers. I don't think shimming would ever be necessary, as you could just not tighten the mounting plate all the way snug. Screw holes aligned perfectly with the holes on the standard round 4" junction box. Got lucky and managed to get the light centered right on the mount. Easy, and done - if it weren't for being a perfectionist. Due to part of the backplate being flush with the mount, it didn't sit completely flush with the ceiling. In fact, it's almost impossible to get it completely flush since the texture bumps will be touching the raised part of the backplate around the mount area. I ended up with no gap on one side, and a big gap on the other, so I had to take it down and loosen/tighten the mounting screws to try to get the gap completely even. I probably took it down and re-adjusted it 5 times before I was happy with the gap evenness (3-4mm all the way around), and many of those times I didn't get lucky as the first time: on subsequent attempts, it was actually quite difficult to center the light on the mount in order to twist-lock it into place. Once complete, the light is beautiful and was actually shockingly bright compared to the "boob light" that it replaced. Too bright, at first, but I've since gotten used to it so I don't think I'll bother adding a dimmer. It has a lot more side coverage than I expected. I have it set to 3000K, and it's a little cooler than incandescent, but I like that. It does have a split second delay to turn on which doesn't bother me, but may bother some.

These are absolutely great lights that are extremely bright, and are very easy to install.