Dongar Dashcam Power Adapter (10-pin Type H) for Hyundai/Kia. Compatible with Select Models, Ioniq 5, EV6, and More. Connects to Rearview Mirror, Built-in USB Power Source, Easy to Install

The device functions by tapping into the powered rear view mirror and the adaptor is ordered by car model. It was easy to install even by a fumble-fingers older installer. The single detractor for which I subtracted one star was the USB-A to USB-C cord was shorter than I had preferred. The USB A extension to the adaptor is long enough to reach the rearview mirror cover near the dashcam which does make the adaptor cord long enough. However, I would have preferred to install the adaptor end inside the plastic rearview mirror casing and have only the cord reach the dashcam. However, the items in the kit function perfectly and my comments only reflect my preference for a cleaner looking install. (The longer cord I wish is available via a third party. Again he product as promised and delivered works perfectly. for BOTH the front AND rear dashcams.

Purchased for year old car and installed it in less than five minutes. Absolutely perfect.I have probably fabricated a couple dozen wiring harnesses and pigtails over my lifetime and always found it a tedious, time-consuming and risky endeavor. First, the build your own, you have to locate an appropriate power source. Second, you have to gather the right supplies including connectors/splices/adapters/wire/soldering iron and connectors, heat shrink, and the list goes on. Then you have to spend an hour or two fabricating, testing, and crossing your fingers. In the end, the frustration level is so great you it adds to the chances you will lose your mind and screw it up.This basic pigtail, on the other hand, comes ready to plug in with good instructions, took less than five minutes to install, and the job looked incredibly clean and professional. What's more, no tedious and risky splicing into the wiring harness of an almost brand new car. Most importantly, the sweet little device was probably close to break-even if you consider the cost of the materials. If you consider the value of time-saved, it was definitely a win.

This was very easy to install and the video made it really easy to follow the routing of the cables.

Worked great in a 2021 Kona EV. Got my dashcam installed and the wiring is up and out of the way. Has been working great for almost a year now. I wish the USB socket were slightly less bulky - it was a little tricky to fit it inside the plastic housing of the mirror mount, but with a little fiddling it all got tucked away just fine.

I purchased this Type-H power tap cable in Jan 2024 for my 2023 Kia Niro EV Wave. Even though my vehicle model year was not listed on the Dongar website's compatibility table, the cable fits fine and works AOK. I had seen some videos showing a very short Type-H cable of maybe 2 inches between the male & female ends of the harness. I was pleasantly surprised to receive a cable that (as shown in the Amazon listing) was a much longer cable of approximately 7-8 inches between the ends (see attached photo). The extra length makes it much easier to install. Also, I had read a few reviews that said the product did not come with any USB cables. I received 3 cables (each cable is 20.5 inches long tip to tip): 1. USB-A to USB-C; 2. USB-A to USB-micro; 3. USB-A to USB-mini. All 3 cables are straight type (no right angle connectors).The cable kit is a bit expensive for what it is IMHO but its worth it for ease of installation of a dashcam.Cheers!

I have a 2025 Kia Sportage, SX-Prestige trim with an ICE engine and, most importantly, the optional Auto-Dimming Mirror with Homelink. So far, this adapter worked just fine with my Rexing V1, 4K Dash Cam. Very easy to put in and I was able to hide adapter in the plastic window shroud covering the sensors. Remember, If you do NOT have the optional Auto-Dimming mirror there will be no proper power source to run this adapter. I have only one complaint and that is that the connector cables they give you are too damn short! I had to buy an extended one. That is why I deducted a star in my rating.

Was super easy to install! The cover for the mirror pops out easily with the included tool. The shrowd around it opens up providing plenty of space to tuck everything neatly. No visible wires anywhere! Works without any other steps aside from unplugging the mirror harness and then plugging in this adapter between.Some feedback: the included usb cables were a nice touch but making them angled 45° would be way neater. I used the cable that came with my cam instead for this reason. It is a lot longer but I was able to tuck it in easily enough.Also, I know all cars are different, but some instructions would be nice. I was able to follow a YouTube video and get it in. Not even the most basic instructions were included in or on the box making the entry level of this item significantly higher; not everyone is comfortable taking these parts of their car off. It's fundamentally easy though given basic steps.

I installed this on my 2024 Santa Cruz and it works perfectly. The only gripes I have are the price and the fact that the connectors are quite large. This prevented me from seating the plastic cover completely after installation. I'm sure I could finagle it into place given enough time but close enough is good enough since you can't tell unless you stick your face up behind the mirror, lol.