Ding All 3 Oz (84ml) Standard Epoxy Repair Kit for Epoxy and Polyester Surfboards Repairs

Used it to fix scratches and dents in a carbon foil, perfect.

This kit works great for small to mid sized windsurfing board repairs.

Albeit, I was a little intimidated by the mixing process as a newby BUT this stuff super easy to use. If you can read the directions you can use this stuff and it works just fine. I bought this ding repair as opposed to the tube because, well, you get a lot more for a mere few dollars more. I used it to repair a fin that went AWOL (FCS plugs and all). I don't understand the low reviews on this stuff at all. If you were dumb enough to damage your board or had a honest accident with your board then I don't see any reason why you wouldn't be grateful for this stuff, unless you would prefer to fix your board with gorilla glue and house remedies. This Ding All provides an acceptable industry standard for repairing your board. This stuff works just fine in my amateur hands and I imagine that the results would be better in that of a experienced repair man.

I’ve used solarEz and now this to repair a crack in my wakeboard. The solarez didn’t last one lake trip before failing. This product already seems better since it’s a re-glass kit. Easy to use. Definitely don’t get the mix on your hands, it was a struggle to get off.

Nobody mention what to do when during the repair process a constant stream of air bubbles exuded from the damaged surface of the SUP. The air bubbles continually got trapped in the fiberglass cloth and resin. In the end, air bubbles were trapped in the resin when it was finally too hard to work. It remains to be seen how the repair holds up. If not for the air bubbles, I believe this to be a very useful products.

Watch one of the YouTube videos about ding repair of an epoxy surfboard before you jump into this. Just like conventional resin except slightly less viscous, requires a heavier mix ratio of catalyst to resin and takes longer to cure. Eliminate all bubbles in any deep cracks. They tend to migrate out and leave craters that may require a refill. For deeper dings, cut up small pieces of glass cloth and mix with resin for filler. Use the mylar to squeeze out excess resin and ensure a smoother finish. Fix all dings and let the board sit for at least TWO days before sanding. My board is white and Krylon Gloss White (available anywhere) is the closest to spec I've found. Wet sand with 400 or finer and then take your time with a buffer.