Plug-in Electric Panel Wall Heaters for Indoor Use, Energy Efficient 24/7 Heating w/Safety Sensor Protection, Patented Quiet Fan-less Design, Easy 2-Min Install, Space Heater, Made in USA

I have to defend these heaters for their quality and efficiency. I own 9 of these and they are my only heat source in an old 1860's 3 story house. I will say before we upgraded some of our insulation, they worked overtime to keep the temperature at 67 during winter here in upstate ny. When the air is wet and cold in the single digits we can barely keep it at 66 to 67. That being said, our home still has wall insulation rated R13 instead of R21 which is the lowest recommended insulation for our area. The outside walls have not been wrapped properly either. Once we upgraded 2 large areas, these little guys pulled their weight and we achieved 70 degrees easily with single digits temps. Extremely easy to install. Safe and durable. I have owned mine for 4 years. Lightweight. Quiet design. I have heard about clicking noise being bothersome, but I am a light sleeper and don't have trouble with mine. The power bill is not too bad but is hard to gage because our power company charges keep increasing.

This heater has really suprised me with how well it works. The rooms I have them in are small and I live in the Appalachian mountains so it’s colder here than other places and this heater still keeps my rooms warm. I have one in my bedroom and one in my dining room. I normally keep these rooms at around 70 degrees and on high these rooms stay at that temperature or a little warmer! I compare these heaters to the old electric baseboard heaters as they don’t have a fan but radiate heat. They have half the wattage of a microwave so now my breaker doesn’t throw when using my heat. I was using a floor heater before and now I finally have my floor space back. They were easy to install and the directions were easy to follow. You will not be disappointed if you use this in a small room.

I was so excited to try these heaters. We have an older home and have used 1500 watt electric space heaters for years, no problem heating rooms. I kept seeing the Envi heater ads on social media, making these look incredible, very safe, efficient and could even help to lower our electric bill. I went all in and purchased three, two of the 500 watt for two approximately 10 x 10 upstairs bedrooms, and one 1000 watt for an approximately 12x 12 downstairs bedroom. Installation was pretty easy, I installed them when our outside temperature was in the forties. One upstairs bedroom seemed to heat the room well, the other, not so much. I kept turning the thermostat on the heater up and up and still couldn’t get the room above 67 degrees. The downstairs bedroom was even worse. I reached out to Envi customer service, thinking the 1000 watt should easily be able to heat our bedroom on a forty some degree day. I figured we had a defective heater and would exchange it. Customer service was a joke, no troubleshooting or anything, just told me that the heater would not work for our space and that we must not have enough insulation. Huh? That was based off of no questions asked by support, so it seems they don’t have much faith in their products working. No help with a return or anything, luckily I purchased through Amazon. This morning is our first truly cold day, outside temperature in the twenties. The heater that seemed to be working well upstairs is struggling, thermostat set the highest, but room temperature is 63 this morning. Second bedroom temperature is 53, that heater is also set to the highest. I just went out to our garage to get our old space heaters. Returning all three Envi heaters. What a joke.

We are on a second one of these having bought the first one 13 years ago. We only use it in a small area with a plug-in thermostat purchased several decades ago. We would had expected the first one to last longer however they are not cost prohibitive. The unit heats well and is the safest we could find for our application. We researched other products when the first one died and did not feel there was are better replacement. Years ago we used heaters that were ceramic style wall heaters that did not have covers in bedrooms. They were not as efficient and without a cover would expose one to a hot surface. We believe, when paired with a separated thermostat, these are a good option for smaller spaces. Compared with most other independent space heaters they are much less likely to cause bodily harm. They are very quiet and attractive. When first initiated they are quite smelly and need to cure over several hours. We would advise opening windows.

Out house has a basement bedroom that is far colder (8-10 degrees) than the rest of the house. If I warm it to a comfortable temperature using our regular house furnace, the rest of the property gets too hot. So, I bought a small fan heater - it worked, but it didn't allow the room to be warmed early in the morning (when someone is still asleep) because the fan is very loud. So, I bought this 500W wall-mounted convection heater. The main reasons for choosing this one were: (i) should be silent; and (ii) it has a pushbutton on/off switch so, by leaving the heater's switch in the "on" position, it should work with a WiFi smart outlet. It took me about 10 minutes to mount to the wall, using the template that is built into the packaging. Plugged it into a WiFi smart outlet. Pushed the heater switch to "on", and turned the thermostat knob all the way to the right. Within moments, I could feel heat rising from the top vents. Bottom line: it works extremely well. It's almost completely silent (I can hear a vague hum when I put my ear next to it, but can't hear a thing normally). I set the smart switch to turn it on at 5AM, so the room is warm when the occupant gets up. Also - for people who prefer a VERY dark bedroom - it has a rather bright red indicator light at the top-right, but it automatically dims in a dark room. All in all, it's a definite 5 stars from me. I'm posting this in May 2025; I'll come back to edit this review if any problems arise.

Muy bonito; nada estorboso, incluso pasa desapercibido sobre todo porque no hace nada de ruido! Muy recomendable

There was no heat in my bathroom. I had to find something that was easy to install and wasn't a portable one. This thing is GREAT! It screws to the wall and plugs in to the wall plug. I was worried about it throwing the breaker, but it doesn't. The bathroom is small and it heats it very well. In fact, it is set on the lowest setting and is never turned up any higher unless it is in the winter and I will turn it up a bit before I have a shower. On it's lowest setting, it isn't running non-stop in the winter. It is the perfect little heater!

We purchased this wall heater for our 10' x 15' Boot Room. It came quickly, packaged well with great instructions (I did find the tutorial of installing helpful for those handy "tips") We were going to hardwire it in, but then chose to use the simple plug in - really liked that the "extra cord" can be tucked inside the unit leaving a clean look. The install itself was simple for one person (thanks to the handy template!). It looks great on the wall, is cool to the touch and whisper quiet! I like the added confidence that if it is somehow comes off the wall it will automatically shut off. Worth the purchase!

Buen producto, excelente precio. Se monta fácilmente.

This is an awesome heater for a bathroom or small space. Easy to install. Safe. No moving parts. Heats surprisingly quickly, Energy efficient. Takes up little valuable space. My only wish is that there was a better range of settings on the built-in thermostat (ie an option to make it a bit less warm - lowest setting is a bit warmer than we really need). Perhaps in a larger space that would be less of an issue (we have it in a very small tiny house bathroom)