Creality Ender 5 Plus Full Hotend Kit, Original Fully Assembled Extruder MK8 Hot End Kit with Aluminum Heating Block 0.4mm Nozzle Teflon Tube for 3D Printer Ender-5 Plus/Ender 5 Pro/Ender 5

As advertised. Replaced my factory hot-end with no problems.

I have Ender 5 Pro and the fan wires that came on this are reversed. additionally, the thermistor appears faulty, when I plug in the thermistor cabling the printer emits a prolonged a prolonged beep alert and the temperature of the themistor reads as -14c, which is the same temperature read when I dont plug in the thermistor at all. Will play with it a bit and see if I can correct the issue, but it seems rather low quality and I will probably return it.**UPDATE** the retaining screw that held in the thermistor was overtightened, crushing the delicate thermistor wire insulation and shorting them against the hot end. I don't recommend this seller. Poor quality control.

This was a perfect fit and an exact replacement for the original complete hot end. It only took me a few minutes to install and everything plugged in exactly right. .I was worried about the wires fitting and the length but it was perfect. I would recommend this product if you need to replace the hot end. I only had to add the wires in the loom for the auto level.

It works... after you fix the reversed wires on both of the fans. It's an easy enough fix, but annoying and takes away from the plug and play convenience.

Installation was easy and worked as it should. Perfect replacement.

Fan doesn't work and it's brand new!! Waiting to see if the work fan actually works. According to others it won't... terrible. I bought aftermarket and used it 24-7 for a month without any problems!!

Completely wired replacement. All I had to do is slip the auto level wires into the new cable keeper and replace all the zip ties.

Works as should but for the price they couldn’t include the fitting that goes on the end of the filament tube.