The Scratch Doctor Enamel Touch Up Paint Silver 15ml | Quick Dry Repair Paint for Baths Sinks Fridges Ovens Radiators & Kitchen Appliances | Fix Chips & Scratches on Enamel Ceramic & Metal

I used this on a Bosch washing machine after the delivery guys scratched it I only saw it after they left ! Well I purchased this based on very good reviews and it doesn’t disappoint, just take your time don’t expect to paint deep scratches with one thick coat as you will make a mess with paint runs my advice is use a low tack masking tape adjacent to the touch up area will be applied especially below as this can run if you use the brush that’s attached to the cap just don’t load the little brush up with too much product wipe it off on a piece of kitchen roll if your brush gets loaded up , it’s expensive but it goes a long way I doubt you would use the lot unless you have large areas to touch up , I can highly recommend this I found the colour a very good match .

Definitely for touch ups only as it’s too thick to get a fine finish over larger areas. Consistency is like thick tip-ex and it starts to dry quite quickly so work fast. This is a pure bright white and my heater it turns out is not as white as this - luckily where I needed to touch up was a big stain on the top edge so I just did the whole top panel in this so it matches in. I could have just left it and saved the tenner but it’s nice to sort out little details and keep on top of the home. I hope I don’t get any more damage to my heaters, but if I do, I’d buy this again. I’ve knocked a star off because the brush came away from the lid so I lost the brush handle which was keeping me from getting messy. I just held it with my fingers - messy but it came off with soap and water. I also could have just used a normal little paint brush. Shame though. P.s have a damp cloth handy if you get any drips anywhere - it just wipes away when it’s still wet no problem.

I bought a new washing machine which got scuffed down to the metal during delivery. The manufacturer gave me 10% off and I spent a tenner of that on this to get it looking good as new. I applied one base coat and then a top coat the next day, which I buffed down with a magic eraser once dry. Bosch decided their machine needed some fancy micropattern but unless you are looking for the scratch you can't see it is there. I actually struggled to find it when I went to check for this review. After a few months of use it has held up just fine to wear and hasn't discoloured either. A bargin which I recommend to you.

I've used this to repair some rusting bath enamel (after using some hammerite kurust), but its really 'gummy' for want of a better description and goes on too thick. As such, its really hard to get a smooth surface. The brush creates streaks if you go over it after the first initial brush stroke and when trying to even out the surface, creating marks. I had to do several coats, sanding down the lumps to get a smooth surface. I will try it again with a bit of white spirit to dilute it and hopefully it might be a bit smoother. The one benefit of this though, is that as I'm repairing enamel on the side of the bath, being so thick means it doesn't easily drip vertically down, which is a useful property in this instance! Still I would prefer a smooth surface and to use a paper towel to catch drips instead. In terms of durability it does bubble up, as it seems the enamel under the bath is still suffering from rust despite it being cured on the exposed parts, though this is more of an issue with the rust itself than this product.

Needed this to cover up a "dink" on a Bath. over the years have used more expensive products and had to re do! This product is easier to brush on, low odour, better consistency (not watery). Repair is invisible. Appears much more durable than the more pricey alternatives (up to now) Would buy again. Recommended. UPDATE 08/04/2025 - Repair still invisible and looking good - not had to touch up or re do! Excellent!

Had a rust line on cooker that looked like dirt/spills and was driving me mad! I was on the verge of buying a new cooker as it looked permanently dirty to me when I thought I'd give this a try first. Covered rust with just 1 coat, but gave it two. The paint is quite runny so be sure to wipe brush to avoid drips, also brush isn't the best but did ok for what I wanted. Fantastic stuff in my opinion. Not sure how it'll stand up to heat when I use the cooker but really pleased with how it covered.

Having read some of the reviews, I was doubtful about using this to repair chips on the edge of an enamel gas hob. I washed down the area, masked the worktop, shook the small pot for about thirty seconds, then brushed on a thin initial layer and left it to dry. It showed an immediate improvement, the colour blended perfectly and another layer of paint dried to a hard, gloss finish. Now, you have to know where the damage was to see any sign of it.

Extremely happy as our replacement dishwasher got a scratch just the edge of the door after only 1 day. Nobody owned up and it could even have been there all along as it only appeared after the usual stickers on the new appliance was removed. It seemed petty to send the whole thing back especially as, in our household anyway, give or take a couple of months there would be grubby prints and maybe even another scratch. So I took a chance on this after reading all the reviews and am very happy with the result. Yes, the photo is of the touch-up which is on the front door near the edge, and no, the teardrop mark is not the touch-up - it is just a grubby fingerprint. The point is, you cannot see it - which is the whole point. Actually, you can see the touch-up, but only when looking side-on from around 20cm from the touch-up as there is a slight indentation. I'm too scared to put on a second coat as it could either hide the scratch entirely, or mess up the job. Like that final touch you make when applying silicon sealant that causes you to smooth over the whole area again.

Ottimo prodotto !!

Super produit idéal pour les petits éraflures marche très bien

L'ho acquistato più di 10 anni fa, ora l'ho riacquistato. Funziona davvero. Impedisce alla nostra vasca di perdere acqua intorno allo scarico. Non si scioglie in acqua calda, quindi rimane intatto sott'acqua. Bisogna riapplicarlo di tanto in tanto per mantenere la tenuta. Dura anni nella bottiglia.

Tolles Produkt, da eine schnelle meines Weber Gasgrills am Emailleteil möglich war. Die Trockenzeit betrag 20 Minuten, fertig. Bin sehr zufrieden.

Très bon produit mais attention : il est BRILLANT, ce qui n'est pas spécifié. À part cela, il couvre parfaitement les surfaces.