Screw Terminal Block Breakout Shield Module for Arduino MEGA-2560 R3

Snaps in place easily and perfectly. Helped make my mega a permanent fixture with solid and snug connection points

I've used a lot of various models of Arduinos, and always find wiring them into the finished product to be a bit of a pain. With this on top of an Arduino Mega, all the pins are exposed with screw clamp terminals to make solid and lasting connections.

Very convenient however, one should start from the bottom because the connectors above impede the screws below.

Works great

Inside these for a home built arguing based flight sim cockpit. They are very easy to use and install. It makes pin visibility and durability what I need for my projects.

It might be a case of getting what one pays for. It is not cheap, to state the obvious. The screw terminals are first class and do not need to be pried open like on other boards. They hold the wires of any gage and are labeled clearly with color coding based on function. There are grounds and +5V terminals at each row. The downside is that the pin layout is not the same as the Arduino, one cannot mount a shield on top like other breakout boards, and no room in the middle for components like prototype boards. Most of the time I tend to use a prototype board with a tft screen stacked on top, not an option here. This worked for me on an application that has two remote displays and needed reliable connections.

I recently built a G1000 using two Arduinos. As you can see from the photos there are a lot of switches, encoders and push buttons. Trying to made solder connections would be a great undertaking. Just in the panel along there are 100 or so solder connections. Just imaging having to do that twice! The terminal board has been a life saver and during the check out phase there were several encoders wired backwards. Easy to made the switch with the terminals vs unsoldering and resoldering the connections. A jewel screwdriver works well and although the terminals are close together it’s way better than the alternative. I did tin the wires to make it easier to terminate the wires.

The product is pricey. A top-quality Mega 2560 itself can cost half as much. So you have to wonder about the price. But this product is very well engineered with all the screw connections very clearly labelled. There is a reset button added too as you cannot get to the reset button on the Mega. The screw terminals make it very desirable for use with other electronics products. A screw terminal connection hardly ever fails unlike a wire plugin into a header. The makers have included a 6-pin header-extender so you can reach the 6 ICSP pins on the Mega board. I have had no issues with this product.

Great quality. The labels are clear. The screws do the job and the layout is good

This makes my Arduino Due (same Lay-out as Mega) much easier to work with. Very well designed and good quality screw terminals that are also all numbered and color coded according to the pins functions. This elevates annoying failures due to single pulled out pins that come unnoticed. Additionally, this is an excellent long term solution for the connections, whereas header pins are quite flimsy i think. A bit pricey but would buy again, makes life easier.

Permite conexiones confiables y solidas buen perfil compacto

computer cabinet

nice breakout sheild to use with your mega board, sturdy screws, works great to interface with my stepper motor drivers, spindle vfd, laser and such , for the one who don’t want to create custom pcb board or mess with flimsy breadboard connectors