Nema 11 Stepper Motor 28mm Body 1.8 Stepper Angle 0.8A 2 Phase 4-Lead

excellent, works well

Quality

Very well made and very powerful works well

Used this to replace the Y Axis Motor on my CR10 - S5. It fitted perfectly but does need the centre pins swapped as the seller states. I reused the Creality cable and if you are careful you can remove and reinsert the pins by lifting the white retraining clips with a small screwdriver. It has been running for a couple of hours now and is perfect.

Like the fact it has flat sides so the grub screws grip but don’t like the fact I had to change the pins around on the motor end of the wire to make it work correctly

Brought as part of a large project, so not fully tested yet. I have tested it on a stepper motor tester and it does exactly what you'd expect a stepper motor to do

Installed as a light weight direct drive extruder motor and is working well. Nice that it comes with a 1 meter cable too.

Used this for a disco ball strong motor good control using a 3rd party circuit board.

Non è adatto per l estrusore perché tende a scaldare troppo.

Ottimo motore in sostituzione dell'originale su una Anycubic Predator ..non servere invertire i fili perchè il cablaggio è già giusto...per la durata vedremo.

Bei einem Zortrax m200 als Extruder Stepper eingesetzt aber VORSICHT bei diesem Drucker nicht plug and play. Beim Zortrax m200 ist ein Zwischenstück erforderlich das ich selbst entworfen habe. Bei anderen nicht erforderlich. Der Stepper arbeitet zuverlässig mit ausreichend Kraft.

ottimo prezzo, funziona

3Dプリンタのトルク不足解消のため、全長47mmサイズの標準品から60mmサイズの本品へと交換。効果を感じられたので追加で購入しようと思いましたが、同サイズは取扱が無くなってしまったようで残念ですが購入できず、代わりに価格帯は違いますが国産の同型モーターを購入しました。