RV Recessed Ceiling Light 2-3/4” Full Aluminum 12V Dimmable LED Puck Light for Campervan Truck Caravan Boat Roof Under Cabinet Lighting, Flush Mount Cutout 2-1/4" (Sliver,Warm White) 4 Pack

Fantastic area lights for my use which is a tad unconventional from what I'm assuming most folks are using these for in an RV or trailer. I put these in the rear hatch of my Jeep to provide area lighting outside at the rear when camping. My interior lights, while being very bright LEDs, just don't throw enough light outside at night. I was worried these wouldn't be bright enough, but they are just the perfect amount of light once its dark out and I'm extremely happy with the output. They work great for ambient lighting at the campsite and are great for fiddling with any gear I'm grabbing from the rear cargo area of my Jeep. They've already been a lifesaver when airing tires back up at night time as well as my compressor is mounted in the rear of my Jeep. I have no doubt these would work well as others have shown in reviews for the interior of an RV or trailer, but if you're looking for a nice area light for a different application like mine hoping this review will help you see how well they work for that. Unfortunately so far the one pic I thought to snap out at a camp site is one with my rock lights on as well as a projector running on my awning - but you can see where the light cut off is for the rock lights vs the Acegoo lights in the hatch as the color temp is different - this will give you an idea of the output outside at night.

We purchased these to replace the halogen lights in our 2005 Carver 444 MY. They are not a direct replacement but very close and wire in easily. Had to make the hole slightly larger to accommodate. Wish they had a spring clip to hold in place. Have used gorilla glue on a few to get them to fit well. They have plenty of light and are easy on the eyes even at night. Good to have less amp draw and updated lighting. They fit flush which is nice as the originals protruded about 1/4". Cleaner, nicer look.

Easy install. Great light quality.

We bought these lights to replace the stock halogen lights in our 2009 Winnebago View. They install fairly easily and appear to be about the same brightness/lumens as the halogens. A couple notes: While the light color temp (*K) is alright, they are not warm white (2,700 to 3,000 *K). They are a bit above that. They have none of the 'orange' tint that an incandescent lamp has. They are clearly "cooler" than the halogens and my 'warm white' LED flashlight. Still, they aren't obnoxiously harsh either. I think most people will find their color temp OK, but that's subjective. We plan to keep them. The wire that the mounting clips are made from is very small gauge, very flimsy and flexible. It makes them a bit difficult to move into position prior to slipping them into the mounting holes, because they twist. Nothing has broken so far, but the mfr could increase the diameter of the wire. The spring tension itself is fine. By comparison, the lights in our range hood use much thicker wire for the clips (the spring tension is a bit higher as well). The aluminum body of the lights feels substantial and the light is well distributed. These lights solved a few problems for us: * They allowed us to replace the halogen lamps with LEDs of similar brightness (if slightly higher color temp). * We were able to replace the fixtures and lenses at the same time -- which was important since the stock fixtures were/are cheap and the lenses kept falling off. * Less energy use * Less heat generated. The halogens will literally burn you they get so hot. They actually melted chocolate in the cabinet above them! It's amazing what 10W can do. Bottom line, assuming they are reliable and long-lasting, they are a good buy.

I chose these lights for the limited space I had in the ceiling of a cargo trailer I am slowly converting to be a livable kind of toy hauler. I have a temporary panel up to keep the insulation in place, and set these LED lights into the panel. Which was super easy to do after cutting the holes with a hole saw, and running wires to a switch by the door. They're powered from either a 12VDC power supply, or the battery/solar side if I don't have shore power. They add the perfect amount of light to the space, were simple to install, and look great. Highly recommended.

These fit perfectly in the holes in by 2000 Beneteau. I only had to pull the old fixtures, disconnect the terminals, crimp new terminals on these fixtures and pop them in. They were a snug fit, but went in just fine. As has been noted elsewhere, the spring clips are fairly light, but seem perfectly adequate for the task. It's a bit of a change in appearance as these are more flush then the old glass dome/chrome ring, but once they're in place no one will notice. And the old ones were starting to look pretty tired anyway. Over the years, I'd replaced the halogen bulbs in the old fixtures with a couple of different generations of led bulbs - none of which ever were completely bright enough to suit me. I was looking at doing another round of replacements - but the bulbs are around $16 each. These fixtures were half the price and 2x as bright! The light color is excellent, and they are so bright that I've paired them with the Acegoo dimmer since I won't want them at full power all the time. When considering dimmers, make sure you get one that works on just the + leg of the circuit - most 12v systems run a separate ground lead for the fixture that doesn't come back to the switch location. The Acegoo dimmer is one of the few that is designed like that.

Much brighter than I expected. Got these because I had clearance issues with my "normal" RV ceiling lights after some remodeling. These worked perfectly. I like the spring retainers, because these lights can be removed easily if necessary. They also work with a PWM "dimmer" controller, and one will provide a night light in the living area. These are close enough to a "cool" 6500 to be what I like. I'll probably replace a couple of the other "normal" bulky lights with these. They do require a 1.25 inch hole saw.

My RV has 15 similar lights in the ceiling and I am replacing them as needed with these. I bought 4 packs of 4 lights to keep on hand. So far I have replaced 3 and they are close enough in design that nobody notices. Also, the light output is exactly the same. The kelvin rating, brightness are spot on (no pun intended) The lights don't dissipate any noticeable heat and that, to me, says they are probably pretty good led bulbs.