2Pcs 2inch 4Ohm 10W Full Range Audio Speaker Stereo Woofer Loudspeaker for Arduino (Pack of 2) CYT1116

Bought 4 other 2" speakers on amazon here for a bluetooth speaker project. all were pretty garbage but there, These have decent bass ability while remaining usable in the mid and high frequencies. They also have a noticeable efficacy increases from the other tested models. almost 2x as loud on the same amplifier while producing better sound. Are they the best? no you can get better speakers. But they may be the best 2" speaker you can get for $14 a pair.

Slightly less powerful than the ones that originally came with my logitech speakers, but the closest ones I could find as far as wattage and impedance. The difference it's not even noticeable at higher volume. Plenty loud and clear! A little modification to get them to fit but it's a great replacement.

I test them and they really not sound good. I bought them to replace the one from my speaker but i was desapointed .Not recommended

These are imprinted 10 watts,at 4 ohms and I believe they are. Much better than standard 3 or 5 watt speakers IF you use a passive radiator to aid in cone movement in your enclosure ( speakers need to be enclosed to work properly ) to get some lower register sound. Eight months later, these are going strong. I have an identical 5W bluetooth and module enclosure that has cheaper speakers that distort with volume up. The 10W Cylewets don't distort and perform great.

DO NOT Substitute these speakers on your JBL Charge 3 They sound the same as my blown speakers Original screws were to small for speaker holes so I had to find screws that wouldn’t go through the holes VERY DISAPPOINTED

I bought these to replace my JBL speakers. Unfortunately i did not look at the positive and negative points facing away from each other instead of parallel and would not fit. HOWEVER, when I attached it to the speaker, the power was comparable to the professional grade of the JBL l and for the cheap price it was, I was impressed. There was zero incident with the connection and performed great. If you're doing a project and have a chamber to reverberate the audio, it's outstanding.

1. It's the same 2inches, 4ohm with 10w (a bit wider or thicker than original from back casing but Fits) 2.the shape of the original is kinda rounded from center areas with gasket (the replacement is straight square without gasket, so i had to peel it from the original) 3.Screws fit just right spacing 4.worked great and sounds just like the original once installed May look different buts sounds the same (if replacing to resale will be obvious that was replaced since they look different) but souds wise will not make a difference... Note... have 2 linked to compare sound with same song playing and they are just perfect playing at the same time (can't tell which one is been fixed)

They work but they kinda suck. Cones appear to be paper and the frame doesn't fit the hole right so you can forget about the unit being waterproof with these speakers. They rattle and distort easily and do not have the highs the originals did. They'll go in and make your Charge3 play music again but it won't be like it was. It's a cheap fix and you can tell.

Fit is a bit tighter than original but bolts in and sounds great

Works like advertised. I would order it again.