BLIKA 120 Pack Stainless Steel Protector Sleeves for 1/8" 5/32" or 3/16" Deck Cable Railing, for Wood/Composite Posts, T316 Marine Grade

Nice pieces,I thought they came in different sizes, but all were the same, which was fine because the large ones was what I needed. They come with the exact size drill which is super helpful. I am using them for a different purpose than cables. I am using them to protect the wood in my Camper for screws to go through and protect the wood and a good fit and looks good and proper. 3/4 Inch from inside collar to end.

These stainless-steel eyes, or guides, or sleve protectors, are perfect for the wire rails system I installed in my deck. The included drill bit is perfect. Drill the hole and the eyes are snug and will not come out. Just perfect. And a great look, too. The sleeves protect the cable and keep it from fraying. And, they make the cable insert and slide through effortlessly. An absolute must if you are doing a cable rail system. And they look great!

These are great quality. They are thick heavy duty inserts. I would buy again. They also came with a drill bit that was long enough to go through my 4x4 posts.

look good work good. make the cable runs look much better where pass thru posts vs without. very tight with 3/16 wire but work fine. would like to see more chamfer edge on the skinny end but it was good enough.

Used for cable railing inserts. Look nice on straight through posts. Could be a bit longer for outside corner bends as they have a tendency to bend with cable run.Also, cheaper than many available, but they still seem seriously overpriced for what they are.Shipping on this item is also very slow- don't expect anything close to 2-day shipping even though it says its Prime.

Purchased these parts for a project but ended up not needing them. They do seem to be well made and should I have needed them, I am sure they would have worked very well.

Nice quality. Right price

Paired with muzata cable railing system. Better and thicker than the other brands. Drilling straight holes is a bit tricky. I’d recommend using a jig before the poles are installed on the deck. Would be a lot easier to get perfectly straight holes throughout. Great product. Wood recommend.