PRx Performance Wall-Mounted Barbell Storage Rack - Space-Saving 2-Bar Holder for Home & Commercial Gym, American-Made, Durable Fitness Equipment, Ideal for Workout and Garage Gym Accessory, Black

First of all, the plate racks came twice as fast as indicated, followed directly by a customer service email making sure that everything arrived as expected. Secondly, the quality of the product is outstanding. I was nervous about hanging the amount of weight we have on a stud system, so I dispersed on two plate racks w/wings. Each rack is holding 245lbs. (490 total lbs.) and is absolutely solid. The bar holder is stellar. The bar doesn't rock, sets in snuggly, and fits under a lower ceiling. I couldn't be more pleased with this system. It has transformed my gym. I used to use an "A" frame plate rack and it took up so much space, did damage to the floor, and I had to take smaller plates off to get to bigger plates stored underneath them. PRx plate storage with wings is efficient, clean, sturdy, and hugely space-saving. All the stars!

These are very well made, I got 2 of them to hand barbells, curl bar and other stuff.

Holding up our barbells beautifully! Slim out if the way design. Great instructions for wall install. High quality.

This thing feels well made. It is heavy and sturdy. Put it on the wall with the included lag screws and it’s holding up my Olympic bar and EZ curl bar with no issues, there’s no wiggle or give when moving the bars. Well worth it to get my bars off the floor. The instructions say to measure the first hole 72 inches off the ground, I think one extra inch might be better otherwise it seem like the bar is scrapping right on the ground.

Super awesome space saver. I've got my 7' Olympic bar and my curl bar up off the ground/off the rack. Little things like that make a huge difference for a space limited fitness room. Bought in conjunction with the same company's wall mounted weight rack. Also awesome, will review that as well. So much more space!!!

My grandson loves it !!!

I think they only actual change I would make to this barbell hanger would be the addition of some protective plastic so it doesn't scuff up the bars. Besides that, sure, you pay a little more because it is PRx but you also get high quality products so I don't mind the little extra it cost.

I've never seen anything like this! We pre-drilled our pilot holes, then went to add the hardware that was sent with the product and both bolt heads just sheared off!! We were using a simple battery operated drill, nothing too powerful. Now, we have to go buy more bolts from the hardware store, and patch two holes with bolt bodies stuck in the wall. Kind of surprised since PRx is such a great company.