Replacement Aluminum Racing Jack Caster Wheels for 3 Ton Floor Jacks (2 Pc Set)

Arrived on time and is exactly what I needed fits perfectly on my jack

Pricey but they seem to be high quality. These replaced the stock casters on a sunex 3 ton aluminum jack. Have had the jack for years and one of the bearing casings gave away and all the ball bearings came out. Looking at the retention pin it’s much more substantial than the original ones (stock ones on left). Although it pained me to spend this amount, I couldn’t t find any others of the same quality. Would buy again

Worked great for my application.

So I bought this cause I have a 3 ton blue point floor jack and one of the original casters broke off. These casters were offered by my search on many websites, so I bought them. They fit perfect with the original bolt, but they are a little too wide, and a little taller than the originals. I can’t say they are better or worse cause I haven’t got the chance to test them or use the floor jack cause it’s been cold where I live to do any job n my cars.

Seem to be better than the original caster wheels on the jack.

Extremely difficult to find. Work great

My cheap wheel broke off of my 2 ton, aluminum, racing, floor jack from Harbor Freight. In order to allow access for the new wheels to swing 360 degrees, I had to use a jig saw to cut out some angles on my jack where doesn't compromise the jack while under load. Also I needed a bur fit into my drill to widen the bore holes a bit just enough to start the wider base nuts on these wheels into it, so that when I tighten down the 19mm nylon lock nuts with my impact wrench, the impact wrench could pull the base nuts the rest og the way into the soft, aluminum bore holes that I burred wider open. With my minor modifications to my jack, the wheels swivel 360 easily, and the wheels are bolted all the way up flush to the jack. If you don't get the same results, you're not thinking of it right. The 1" shaft stems are the right height for the jack's thicker aluminum metal which is 25mm. And these wheels are fabricated with enough metal material all around that I doubt these ever break like the cheap originals do. I still have yet to see how well the grease and ball bearings hold up over the years. I can regrease the bearings as need though, so...

I don't have to tell you these cost a lot but they fit my Walmart 3tn jack very well. The old wheels were steel and they rusted so badly they wouldn't move. These are aluminum and won't rust. The downside is they are softer so if you aren't rolling on a smooth surface they will get scuffed up fast. Worth the money.

Great set to fix my floor jack. A bit more expensive but worth the money compared to other items.

Crazy expensive (Why I gave 4 stars rather than 5) and it turns out they are a bit larger than my jack original wheels, but that's a good thing. Also much heavier construction than the OEM wheels. Highly recommended, if you can afford them.

I have been looking for a steel caster for years to replace one lost on my floor jack. This worked perfectly although I had to add spacer washers to get the post to a position to enable tightening nut.