POWERTEC 2PK Toggle Clamp, 500 lbs Holding Capacity, 12130 Quick Release Vertical Clamps w/Antislip Rubber Pressure Tip for Woodworking Jigs and Fixtures, Welding, Drill Press, Crosscut Sled (20335)

These are very good, they hold the work piece well, have good adjustability and lock down well.

The media could not be loaded. These toggle clamps work great and are well made. I use them to clamp down work pieces on the drill press. They are adjustable up and down and front to back so they can lock down different depths and widths. They provide firm solid clamping that prevents the work pieces from moving while working on them. I no longer have to hold workpieces with my hand and hope they don't wiggle while drilling.

The only reason this didn't get 5 stars is because the product description doesn't make it obvious that this is a SURFACE clamp. This is basically a surface clamp +- 1/4 inch. i.e without additional blocking, mounted on the same surface as the workpiece, the workpiece can be up to 1/4" thick, or the pad can be adjusted to clamp at 1/4 inch below the clamp surface level. Yes, you can clamp a 2" board, but only if you mount it on a 2" block. Just like you can clamp 6 ft block, if you mount it on a 6 ft block. That aside, it suited my purpose just fine for making a jig to cut large panels of OSB. I thought I would need both clamps to hold the jig securely against 8' panels, but just one suffices as it has great holding power.

I’m always pleased with power tech products. They work well and they’re priced fairly.

These work well.

I used these to make a coping sled for my router table. Works great to hold the material in place and allows quick release for working a lot of pieces without a lot of fuss.

these work as a great more cost effective solution to the competitors, but i would question the strength as they are definitely not made with the same quality materials as staco brand clamps

Bolt down and hold the product great.