maXpeedingrods Pack of 2 Triple Bellow Air Spring 2600 lbs Air Suspension Bag 1/2" NPT Single Port Universal Replacement

Love them

I have a personnel lift that I want to be able to operate without having to remove it from my utility trailer. In order for it to operate correctly, the base- i.e. the trailer floor, needs to be level. By installing these maXpeedingrods Pack of 2 Triple Bellow Air Springs on my trailer axle and using independent air controls and a small 12 volt compressor, I will be able to level the trailer using the tongue jack stand as the third support point. These air springs will also add to the stiffness of the trailer leaf springs to establish a stable platform.These are an economical solution for my project requirement. They seem well-built and the roughly 6 inch travel makes them applicable to a variety of uses.

They seemed fine and the size was what I wanted. I don't care for them as they leaked and seem pretty flimsy and doubt they will be off any use for offroading applications.

Pappy sez,I think most all of the listed specifications for this set of bags is pretty accurate. The one thing I didn't see listed was the diameter of the bellows (the bag part), they measure about 7 inches diameter. If you intend to use these for a front spring application you will want to make sure you have spring pockets large enough.They are about 5 inches tall fully compressed (by hand) and they do not have any kind of internal bumper, so a minimum 5-1/2 inch deep pocket will be needed.They seem like well made bags I don't see anything that looks like obvious quality flaws.I hope my review and Pictures were a little bit HeLpFuL to You !!

If your air suspention bags have failed and leak these are a good replacement solution. These seem to be well crafted and will get your suspention back to it's former glory. These are good parts from a known parts supplier. Recommended.

Got these for an ongoing project building up a leveling system for my van. These seem to be airbags with the most amount of travel for that task. They're also not super heavy like some. A lot of work ahead to see how well these hold up, but I'm hopeful from what I see so far.

The quality of these airbags is excellent; they ride really well. They were easy to install. All you had to do was read the instructions for sure. So clear and simple and made it really simple to follow I really think that's excellent value for the money. I'm really glad I got it

I needed additional raise abilities in my current project. I was concerned due to other reviews and decided to build a quick jig to enable pressuring without over extending. The bags have maintained there pressure for over a week. Caution is required when tightening any tapered brass connector and a good sealant is required in my opinion. I wish that the manufacturer would provide specifications with the bags to aid with designing mounts.