VideoSecuVideoSecu One Pair Height Adjustable Speaker Stands Mounts Heavy Duty Floor Stands Surround Sound Satellite Small Bookshelf Speakers Stand MS08B DA8

These were recommended by a guy on the home theater forum I am a member of, they are a big winner!I use these for my rear surrounds, I got them up to ear height which improves the sound of the system as a whole. They are solid and have a variety of ways to attach the speakers to the stands, there is also a way to route the cables inside the shaft of the stand which gives everything a nice finished look.HIGHLY recommended!

A bit flimsy but does the job. Recommence speaker that have a proper center of balance.

There are various ways to mount speakers to these stands. I have a Yamaha home theater in a box and recently mounted my tv to the wall. So I changed to a much smaller tv stand and had to figure out a way to mount the front 2 speakers. I actually may replace my rear stands with these stands and just donate/toss the old ones, as the base wobbles and is not as sturdy, nor is the pole wide enough to hide the speaker wire. I have the thicker speaker wire (https://smile.amazon.com/Monoprice-16AWG-2-Conductor-Speaker-Installation/dp/B001UNJVJW/ref=pd_ybh_a_43?_encoding=UTF8&psc=1&refRID=33TFCHXM955XDK9SPBTA) and the pole holds these with plenty of room to spare. The base is big and square so it does not move. Putting the stand together only takes a few minutes. You will need a phillips screwdriver in addition to the provided allen wrench. It's height adjustable so make sure it's all the way down when putting together. Then adjust as needed, which is easy to move up or down, the knob to tighten is big and easy to grip. Highly recommend this speaker stand if you have a HTIB sized speakers.

Finally completed my 5.1.2 Dolby Atmos living room setup (running 3 subs so it's actually a 5.3.2 configuration - Dual 15"s upfront and a 8" behind the couch as you can see in the photos.), but these stands are fairly sturdy! Only thing I wish were the bottom bases to be a bit larger to give it more of a sturdier base, but I have them slightly tucked under the couch so I'm not to worried, I have the Pioneer Andrew Jones series speakers, and my rear bookshelves are the SP-BS22s, they are fairly large and weight about 10lb which is perfect, but they totally sit snug on the stands, even with though they are much larger then the top base, I didnt want to put any holes in my speakers, so My mounting method is literally just the provided 3M double sided tape between the gaps, and I also added heavy duty 3M tape on top of that as well as the back brace is as well 3M Heavy duty . And these babies wont come down even if my little one bumps it hard. Only way they'll go is if someone literally punches them or rips them off, which I'm sure could he the case with ANY speaker even towers haha. But these hold up very very well! Again I'm extremely happy with my purchase and I'm even more happy that now my living room system is complete and can enjoy a immersive experience with my family. HIGH RECOMMENDATION.*ALTHOUGH If your speakers are a bit larger, these might not be your first choice. So just be aware cause these will tilt over with larger speakers. *

These are exactly what I was looking for. They are solid, sturdy and assemble easily. According to the directions, they can support any kind of speaker you have and my super cheap ones that have no mounting holes at all are secured nicely to the adhesive pads they provide. I am using these for a gaming setup and needed them at around 43" and they are just the perfect height for that.Note that if your speakers have RCA plugs they will not fit through the cable routing hole. I had to do some cutting and splicing of my cables, and while it wasn't a huge deal I could see this being a no-go for others. Normal speaker wires would not be a problem, it was the plug on the end that was the problem.In the end, I am more than happy with these and would definitely recommend them.