Fill-Rite FRBN100AS 1" Fuel Transfer Automatic Nozzle (Green) w/Swivel

Must have for pumping out gas barrels. I use fluorite . Both pump and filter work great. Highly recommend if u r pumping fuel. Especially if it's been stored a while

The filrite see through filter is a great product. Easy install. But a bit too pricey.

Filter kit is really a good value at this price. The box states made in USA as does the filter can itself. Installation is straight forward. The long section of pipe that is included with this kit was way too long for my application. I didn’t want my filter hanging 10” away from the pump. This creates a lot of leverage and I can see the cast pump being damaged accidentally with that much leverage so I used a short piece of pipe I had laying around to get it mounted closer. If I had to go to the store I would have bought one about twice as long but this was laying around in a bin at the shop so I used it. All in all I am very happy with the fill rite pump and filter set up. I got the pump on amazon warehouse for $125 so I’m at around $160 for pump and filter. Not bad for something that should easily last a lifetime. It’s light years ahead of my old cheap made in China pump that leaked everywhere.

Used this on my hand crank pump that is 20+ years old. It a Tuthill which is now Fill-Rite. I did use a GPI installation kit to replace the long pipe this kit comes with. It’s just way too long in my opinion. The part number to that is 110528-01. I got it at Tractor Supply. But I tested it, seems to flow very nice. I was concerned that there might be too much back pressure. But theres not a whole lot. Would definitely recommend this for keeping your fuel clean

Do not use the pipe fittings - They are a one time use only - The base is great glad I bought it but Pipe fittings are not worth your time.

I had no trouble installing mine at all -- of course I didn't do like everyone else that complained about it did with the straight up pipe then the elbow... I came out of the pump with the elbow and used the straight to get clear of the pump etc. As my tank and pump setup is designed to fit around and under my retractable bed cover -- going verticle would have been an issue for me. Even on the directions there is a big asterisk ** on there that says one "possible" configuration.. you don't HAVE to do it that way. Worked great in my situation.

I was changing my plumbing on my fuel farm so I changed my filter system plumbing too.. Great filter kit. Hooked up to a fill-rite 15gpm pump system, no appreciable loss of volume.I use this on my low volume diesel fuel but use the other less expensive brand, the one named golden rod - no space, on my unleaded tank - if there is an issue between the two I haven't seen it yet in the 20 years I've been using them, besides I'd rather lose a 5-10k crate motor than a 40+k tractor/farm vehicle motor if the golden one fails. 🤣😀🙂Hope this helps

Changed out the galvanized pipe and elbow and went to Stainless due to theory of Diesel reacting to Galvanized