BGNing 2212 2200kv Brushless Motor Outrunner W/Mount 6t + 30a ESC Controller for Drone Rc Quadcopter Multi Copter UFO

The media could not be loaded. I think a product of this price is awesomeI wouldn't be expecting the Best of it because of the price range but I can say that we are lucky to get a motor as good as this one and as for the ESC we should just figure something out

Product arrived in mostly okay condition, the only thing to note is that when I first ran the motor, it stuttered a bit, then noticed that said motor was out of phase- after checking the leads on the esc, motor, and the bullet connectors, there was a bit of corrosion, and I noticed that only about 3-4 of the copper strands per wire had solid solder points. I cut, restripped, and resoldered all of the connections, and it worked a charm.

Awesome little motors for the price. They seem to turn with power and haven't had any problems. I put one of these on a flute test mini arrow and it flys great on a 2s or a 3s. NOTE: these esc units do not disengage when the prop can't spin, they will just keep trying and may burn something up. If you crash make sure to chop the throttle so you don't have any problems.

Good deal on this setup. You can't beat these gold bell motors, keep the bearings lubed and they last! I have a 2212 1000kv that's over 6 years old and its still running on original bearings. Lube them every 6 to 8 flights and make sure the C clip is not wearing out. This motor screams compared to the old one!

received without motor mount, screws, and nut for prop

So far this motor has performed beautiful and cant wait to get more flights in.

The motor quality is fine excepting the motor leads were way over heated when tinned and I found solder up half of the leads making them very stiff and brittle. I had to cut the leads down and re-tin them prior to applying the typical 3.5mm bullet connectors.The ESC that I received was nothing like the one shown in the photos. The 30a esc I received was loaded with SimonK firmware and is not programmable. I build flying wings and it is imperative that you program the ESCs for "brake on" because you typically land wings in the grass and a non-braked, rotating prop will most likely break on landing.The supplied ESC is therefore useless to me.Given the price, it's just not worth returning ... so, beware of what you may end up receiving when ordering this product.

for rc model