GM Genuine 19209664 Liftgate Emblem, Gold

Great product

I have a 2008 Chevy HHR LT and it was difficult to identify what part to order because it is a factory defect that the outer bowtie comes discolored and will eventually fall off. Just look at HHR's in parking lots. A friend tried to repaind the plasitc outer bowtie and reglue it. I looked great for 3 days.This is official GM part. I wondered if I would have to unsrew the hex bolts underneath the tailgate/ switch mechanism. I did not want to. I was not sure how the bowtie was attached since I had already repainted/ glued it 6 months prior.Here is the deal: the bowtie/ the same that comes from Amazon, Is attached to the vehicle by adhesive. So, in order to attach new Bowtite emblem, you must remove old with out scratching paint. Notice 2 studs in picture and peel back adhesive strip. That's what there is once you need once old emblem is removed. After much discussion, I said screw it, I'm going to do take it off gently. It was a hot day, I recommend that or a hair dryer in a pinch. I took a long razor blade utility knife and carefully worked my way in between the emblem and the vehicle in a back and forth motion. Basically, you are sawing the adhesive with that long razor sharp utility knife. It took some time.Remember the 2 studs to work around finally I removed it. There was much black adhesive remaining which I remove with Goof-Off and several tack cloths. It also provided a clean surface to apply the new emblem. I lined the 2 studs to 2 holes in the body of the car, removed the adhesive protective strip and careful stuck it on, held with pressure for 2-4 minutes. It looks like new. Not bad for $30

This product will update the car with a new emblem!!

Same as above. Took it to my mechanic after a two week wait for a scheduled appointment. Could not send back to have it exchanged. Had to use it and now emblem does not fit on tailgate correctly. Extremely disappointed!

I ordered 2 from other sellers and they were not the right size or fit. This has the bend in it and is the same size.

Easy to put in

Fit perfect on rear hatch of 06 HHR

Removing the old adhesive is what's a bit more work. I used a sharp but thick blad/knife to kinda slice behind the old emblem. After prying it off I just used my fingers to rup and pull away old adhesive tape, then some goo gone. Probably too much 9f a perfectionist but after completely removing all leftover sticky tape I simply placed this into place slowly and applied steady pressure for like 5 seconds. All done.