Precision Applications of Glue, 3ml 5ml Syringes and Blunt Tip Needles(14 15 16 18 19 20 21 22 23 25 Ga), for Liquid Measuring, Craft Paint, Epoxy Resin, Oil or Adhesives Applicator

I'm sure they work really well with glue because I fill them with spackle to fill in nail holes in sheet rock. I hang paintings ceiling to floor salon style so I have a lot of nail holes.

Looks like these will work for adding damping oil in a record Turntable. They seem well made and the various sizes of the needles should do.

100% would buy again.Purchased this kit to assist in getting glue further down into a crack in a Les Paul guitar neck. Thinned Tite Bond glue a bit with water so it was easier to move from the syringe through the needle and into the neck.Using this kit was great. Would suggest it for any glue job which needs a bit of precision or you simply don't want to make a huge mess. The syringe gives you great control on how much is applied and where the glue goes.Clean up was easy with a drop of dish soap and warm water. The syringes and needles will go on to repair again.

I bought these with Gem-tac glue to use to apply rhinestones to rubber ducks. It took me a while to figure out how to fill & use them 😳Pro: they help me keep a small steady like of glue and the glue doesn't dry out while in the syringe like it did when I just poured it out on a plate & used a tooth pick to put it on the duck.Con: there's no way to keep the glue from drying in the tip between uses (although the glue in the syringe doesn't dry out)... I put the whole thing in a ziplock bag, but that doesn't seem to help, so I have to clear the tip of dried glue each time I want to use it.You could just clean the whole thing with soap and water between uses if you emptied it of glue each time, but I never seem to do that.

Great item

So nice and handy I have used these for many different purposes. Easy to use, reusable.

I'm repairing some old chairs and a table where some of the curved pieces had partially come apart. With these syringes I was able to inject glue deep into cracks/seperations. Then I used an old playing card to spread the glue around in the cracks. Some clamps and dry time, the repairs are invisible. The syringes cleaned up so they can be reused! Great tool in my toolbox.

Very difficult to load with glue even with large needles and just as difficult to inject glue into project.