BIG RED Hydraulic Low Profile Service/Floor Jack with Dual Piston Quick Lift Pump, 4 Ton (8,000 lb.) Capacity

Using the long length saddle, this jack slides under my Subaru Outback and enabled me to get a jackstand under it such that a good looking man of my girth can safely slide underneath to perform maintenance. Other jacks didn't lift high enough, this one lifts up to 20 inches in height, so I highly recommend it. The jack itself is heavily built of steel with massive side members that hold the whole device perfectly rigid. The 3 ton hydraulics work very smoothly up and down and lifted my 1.5 ton wagon with little effort. It comes with a yellow nylon handle that I snapped into place which made it much easier to carry. The red paint is flawless and not easily scratched. I felt confident in my safety using this well made tool. For the price I was pleasantly surprised at the quality & finish.

Super. Very happy!

Everything works fine but I got a used version and it didn’t come with the handle. But the capacity checks out, it works for low profile cars perfectly

The media could not be loaded. I bought this for when I get a flat in my car. My edge came with a horrible jack so I decided to invest in this! The carrying case makes it super easy to move around in the back of my car and the time I did have to use it I was thankful I had it because the jacks they put in cars today is not sturdy. I was not worried about this falling at all. It was so nice to just pull it out of the back and raise my car up! A definite lifesaver for flats on the side of the road! Not too big like my floor jack so the size is great for storing in a vehicle!

Incredible. I just finished changing my brakes and rotors and this thing helped a lot. I cannot believe you can get an entire portable floor jack delivered right to your door for $50. Needed it asap for my car work and it showed up quickly and worked perfectly. Note that it's not tall enough to lift up one end of your car at once. It doesn't reach high enough (not on my 2016 Civic anyway) to lift the entire end up so you can work on both front/rear tires at once. Wasn't a problem though. I used it to lift at the jack point directly beside the tire that I wanted to work on.I'm not sure if this is advisable, but I used the floor jack to jack the car up on the rib directly beside the jack point that I wanted to use. That way, I could get the jack stand under the jack point directly beside the tire that I wanted to work on. If you don't do it this way then I'm not sure how you would get the jack stand under the jack point next to the tire. The jack would be occupying the spot that you need to put the jack stand under so ? This could be the wrong way do it, though, and maybe you should use a different floor jack entirely if this is what you need to do. It worked for me though, and the rib didn't show any signs of damage from using it this way.The product itself worked perfectly and was able to lift the car up without much difficulty. Just make sure to follow the directions prior to using it as there are clear directions instructing you to bleed any air out of the system prior to using it. After that, it worked perfectly fine and I'm really glad that I got this product.

No complaints whatsoever. Used this with a Lexus SUV and it was solid. Didn't need the low-profile design but it didn't affect the performance even with a moderately sized SUV. The only thing I would change is including some kind of adapter for the jack point seam that most cars have. I cut a slot into a 2X4 (perpendicular to the grain) and lifted my RX to do brake pads & a caliper. No sag whatsoever in a 2 hour job

0. Packaging was terrible. It's heavy and they put the jack in an oversized box. The jack is about 3/7 the width of amazon box and 3/4 in height. It was hell for the deliver man when I watch the footage from my camera.1. Oil spilled, all of them, before I opened the package. The manual was bathed in oil and almost impossible to read. To be honest, I did not figure out the wet box was from the oil (didn't touch it) and the manual was drenched in oil. I thought I could see the other side of each page in the manual was because of the poor paper quality. I was new to this equipment, so I spent 1 hour to figure out why the jack barely raised (because it was out of oil if you wonder).I followed the manual properly despite the manual was oiled. 1st time use: release the valve, pump 10-15 times, open the cover, take a flat screwdriver to push around the edge of oil plug to release any air trapped inside, close the valve.I assumed it was due to poor shipping. So I bought some jack oil to refill. The jack raised as it should. I was happy for 1 minute until I saw the floor was wet with oil. It was the oil leak.The oil was spilling constantly from the bellow of the oil container thing and the piston (I don't know proper names of these parts, sorry). I was hoping it was temporary, but all of the oil eventually dripped to the floor.2. I am returning this. Not giving this any other chance because of the rubber oil plug horror.The oil plug. The freaking thing is the test of strength to BOTH unplug and plug in. The manual warns about not treating the plug too rough or it would be torn. But it is impossible to remove the plug without going rough with flat screwdriver to help.And I did my best to read the oiled manual to see if there's any intelligent way to smoothly remove the plug. None. It only tells me to unplug. No technique, no tool, no How-to from the internet. I couldn't find any video showing how they remove the rubber type oil plug. That's it. It is time to go super rough.My uncle is physically strong since he works at warehouse for most of his life, and he absolutely refuses to deal with that thing again. To push the oil plug in, I have no choice but getting a screwdriver with head around 30mm diameter (to fit in the hole on top of the plug), with a somewhat thick rug in between, to push/drill/stab the oil plug in without destroying it.It boils my blood even more when I see other models on Youtube, they make the oil plug unscrewable.

Shipped fast, heavy duty. Nice jack, smooth operation. Heavy but very solid. Would recommend for lifted trucks etc